Laserfiche WebLink
*,,SANTA <br />NA-'hffi <br />Planning & Building Agency <br />Building Safety Division <br />20 Civic Center Plaza <br />P.O. Box 1988 (M-19) <br />Santa Ana, CA 92702 <br />(714) 647-s800 <br />www.santa-ana.org <br />RESIDENTIAL <br />PHOTOVOLTAIC <br />CHECKLIST <br />soL-01 cBc 2013 <br />Solar Photovoltaic (PV) Checklist for Oetached SINGLE FAMILY RESIOENCES Only <br />lnstructions: The licensed contractor of record shall complete all sections, answer the ten questions and <br />sign the certification section below. A copy of this form shall be atlached to each of TWO sets of plans, of <br />minimum 1 1' x 17" size. lf answerinq NO to anv of the questions, Dlan check shall be iequired. <br />Proiect Address:745 W ASTER PL, SANTA ANA, CA 92706 <br />Contractor Company Name: <br />Conlractor License Numbet: <br />SOUTHWEST SUN SOLAR, INC <br />1004667 <br />1 <br />YES NO <br />E tr <br />Are the following applicable to the proposed proiect? <br />Will the PV system layout provide the required three-foot wide clear access pathways <br />per Section 605.1,1 of the Califomia Fire Code, and is this shown on the roof plan? <br />Will the PV system be installed on a roof having only one roofing layer with no <br />overlays? <br />Will the PV anay be flush mounted to the existing roof so that the plane of the <br />modules (panels) are parallel to the plane of the roof? <br />Will the PV system weigh maximum 4 pounds per square feet or less? <br />Will the PV system be installed where the modules do nol overhang any roof edges <br />(such as eaves, gabled ends, ridges and hips)? <br />Will the PV system be installed with a space of 2" minimum to 10" maximum between <br />the undeBide of modules and the surface of the roof? <br />Will the PV system be installed without using any ballast system or counter-weight <br />system? <br />Will the anchors be installed with a maximum horizontal anchor spacing of 6 feet <br />and is this maximum horizonlal spacing shown on the plans? <br />Will the minimum 5/16'' lag screws be installed with a minimum of 2-1l2 inch <br />embedment into roof rafters (with pre-drilled holes) and is this minimum embedment <br />shown on the plans? <br />Are ALL the slructural pages of the plans WET stamped and signed by a California <br />licensed professional engineer? (including project specific site plan, PV layout, <br />anchorage spacing, anchorage details and manufacturefs PV support information.) <br />./ <br />4 <br />2 <br />6 <br />7 <br />8tr <br />Etr <br />Eltr <br />Etr <br />Ettr <br />Etr <br />8 Etr <br />e. Eltr <br />'10 Etr <br />I certify under penalty of perjury under the laws of the State of <br />Print Name: l\re Signature: <br />phone Number: 714 582 3909 Date <br />California that the <br />l. <br />above i 'r <br />j <br />Email Address <br />Rev:8/1712015 <br />PERMTT@SOUTHWESTSUNSOLAR.COM <br />a/