26 Civic Center Plz - REV 7 - Plan

Home Browse Search

I U E I H U 9 AS.O A FRANCN 4 0 8 0 H I N S L11 AL E CR NDEN VA ,N I N G CRAE TCEI T SC S N N G R O U P 7 S 5 06 C 07 18 2 P R A O 90 A EU C + ER 4 SHEET TITLE AND NO. ISSUE DATE PROJECT: CA REG. Project Arch.---- ---- 22575-01 26 CIVIC CENTER PLAZA SANTA ANA CA 92701 SANTA ANA LIBRARY RENOVATION CITY OF SANTA ANA 26 CIVIC CENTER PLAZA SANTA ANA, CA 92701 ELECTRICAL-PLMUMBING-MECHANICAL 1920 MAIN STREET, SUITE 820 IRVINE, CA92614 TEL: 949.516.6480 BID SET FINAL PERMIT/CONFORM SET 04/30/2024 08/02/2024 E1.0-2 ELECTRICAL LIGHTING SITE PLAN 1 CONDUITS SERVING SURFACE MOUNTED TRELLIS LIGHT FIXTURES SHALL BE PAINTED TO MATCH COLUMNS. 2 EXISTING LIGHTING FIXTURES TO REMAIN AND BE PROTECTED IN PLACE. CIRCUITING IS ASSUMED TO BE CONNECTED BACK TO PANELBOARD "LP" IN BASEMENT LEVEL OF LIBRARY. CONTRACTOR SHALL CONFIRM (CIRCUIT TRACING) AND LABEL CIRCUITING ON RECORD DRAWINGS. CIRCUITING SHALL BE CONNECTED THROUGH NEW LIGHTING CONTROL PANEL (LCP). 3 EXISTING LIGHTING FIXTURES TO REMAIN AND BE PROTECTED IN PLACE. RECIRCUIT AS SHOWN AND INDICATED ON SHEET E1.0-2. 4 EXISTING LIGHTING IN KIDS EXTERIOR PLAYGROUND AREA TO BE PROTECTED IN PLACE. RECIRCUIT AS SHOWN AND INDICATED ON SHEET E1.0-2. 5 EXISTING LIBRARY UNDERGROUND VAULT TO REMAIN. EXISTING ELECTRICAL EQUIPMENT TO BE REMOVED FROM VAULT. NEW PULLBOX TO BE PLACED IN VAULT TO EXTEND FEEDERS TO NEW MAIN SWITCHBOARD LOCATION. GENERAL NOTES KEY NOTES 1. REFER TO ARCHITECTURAL PLANS FOR EXACT LOCATION AND ELEVATION OF ALL LIGHTING FIXTURES AND ALL LIGHTING CONTROL DEVICES. ALL WALL MOUNTED DEVICES SHALL BE VERIFIED WITH ARCHITECT PRIOR TO ROUGH- IN. 2. CONTRACTOR TO REFER TO DRAWING E0.02 FOR FIXTURE SCHEDULE. 3. CONTRACTOR IS RESPONSIBLE FOR PROVIDING LIGHTING FIXTURES WITH REQUIRED STRUCTURAL SUPPORTS. 4. REFER TO ARCHITECTURAL PLANS FOR EXIT SIGN CHEVRONS AND NUMBER OF FACES PER EXIT SIGN. ANY DISCREPANCIES BETWEEN EXIT SIGNS SHOWN ON ELECTRICAL AND ARCHITECTURAL PLANS SHALL BE BROUGHT TO THE ATTENTION OF THE ARCHITECT. 5. REFER TO DRAWING E3.03 FOR LIGHTING CONTROL DIAGRAMS AND DETAILS. CONTRACTOR IS RESPONSIBLE TO PROVIDE ALL LOW VOLTAGE WIRING AND COMPONENTS TO PROVIDE A COMPLIANT AND FULLY WORKING LIGHTING CONTROL SYSTEM. 6. ALL PENETRATIONS THROUGH FIRE RATED WALLS SHALL BE PROTECTED FROM SPREAD OF FIRE WITH AN APPROVED FIRESTOP SYSTEM EQUAL OR GREATER THAN THE FIRE RATING OF THE WALL. 7. CONTRACTOR TO PROVIDE JUNCTION BOXES AS NEEDED FOR A COMPLETE LIGHTING INSTALLATION. THESE ARE NOT SHOWN FOR CLARITY OF DRAWINGS. NO JUNCTION BOXES SHALL BE INSTALLED IN HARD-LID CEILINGS. 8. CONTRACTOR TO PROVIDE CONSTANT HOT CIRCUIT TO ALL EXIT SIGNS AND LIGHT FIXTURES PROVIDED WITH 90 MINUTE BATTERY BACKUP FOR EGRESS. 9. ALL PENETRATIONS THROUGH FIRE RATED WALLS SHALL BE PROTECTED FROM SPREAD OF FIRE WITH AN APPROVED FIRESTOP SYSTEM EQUAL OR GREATER THAN THE FIRE RATING OF THE WALL. 10. EXPOSED CABLE/CONDUCTORS INSTALLED IN A PLENUM SPACE SHALL CONFORM TO CEC, ARTICLE 300.22(C). 11. PROVIDE ADDITIONAL J-BOX NEAR PANEL FOR MULTIPLE HOMERUN CIRCUITRY. 12. WHEN EXPOSED CEILINGS OR OPEN GRID CONDITIONS OCCUR, THE CONTRACTOR SHALL PROVIDE THE FOLLOWING: 14.1 ALL BRANCH CIRCUITS SHALL BE IN EMT CONDUITS 14.2 ALL BRANCH CIRCUITS SHALL BE ROUTED, NEATLY AND IN PARALLEL TO STRUCTURES OR DUCT WORK. 14.3 VISUALLY OBJECTIONABLE BRANCH CIRCUITS SHALL BE REROUTED AT THE REQUEST OF THE ARCHITECT AT NO ADDITIONAL COST. 13. PROVIDE DEDICATED NEUTRAL FOR EACH NEW CIRCUIT, EXCEPT WHERE OTHERWISE NOTED. HOME RUN CONDUCTORS MAY BE COMBINED INTO ONE CONDUIT. NO RACEWAY OR CABLE SHALL CONTAIN MORE THAN NINE (9) CURRENT CARRYING CONDUCTORS. WHERE MULTIPLE CONDUCTORS IN EXCESS OF THREE (3) ARE INDICATED ON THESE DRAWINGS, THEY HAVE BEEN DERATED AS REQUIRED BY CEC ARTICLE 310 REQUIREMENTS. 14. CONTRACTOR SHALL VERIFY WITH LIGHTING CONTROLS MANUFACTURER THE TYPE QUANTITY AND BEST PLACEMENT OF OCCUPANT AND/OR PHOTOCELL SENSORS AS SHOWN ON FLOOR PLAN. PER TITLE 24, OCCUPANT SENSORS SHALL BE MOUNTED AT LEAST 4FT AWAY FROM AIR SUPPLY REGISTER. 15. CONTRACTOR SHALL PROVIDE STARTUP AND COMMISSIONING SERVICES FROM LIGHTING CONTROL MANUFACTURER TO SET UP, ADJUST AND PROGRAM SOFTWARE SYSTEM FOR THE LIGHTING CONTROL SYSTEM TO PROVIDE A COMPLETE AND OPERABLE SYSTEM. 16. NOT ALL JUNCTION BOXES ARE SHOWN ON DRAWINGS. CONTRACTOR SHALL PROVIDE FOR A COMPLETE LIGHTING SYSTEM. 17. ALL OUTDOOR LIGHTING, LIGHTING EQUIPMENT AND CONTROLS SHALL BE WEATHERPROOF (NEMA 3R) AND SUITEABLE FOR THE APPLICATION. 6 CONTRACTOR SHALL PROVIDE HANDHOLE ADJACENT TO NEW LIGHT POLE TO ENSURE SEPARATION OF POWER AND LOW VOLTAGE CABLES IN POLE. COORDINATE CONNECTION TO LIGHTING POLE IN THE FIELD AND CONNECTION TO POLE MOUNTED SECURITY CAMERA IN THE FIELD. COORDIANTE EXACT LOCATION OF HANDHOLE IN THE FIELD. 7 CONTRACTOR SHALL MOUNT FIXTURE ON SIDE OF TRELLIS. CONDUITS SERVING SURFACE MOUNTED TRELLIS LIGHT FIXTURES SHALL BE PAINTED TO MATCH COLUMNS. 8 CONTRACTOR SHALL PROVIDE JUNCTION BOX FOR NEW LIGHT FIXTURE MOUNTED TO PICKET FENCE, TO ENSURE SEPARATION OF POWER AND LOW VOLTAGE CABLES. COORDINATE CONNECTION TO LIGHTING FIXTURE IN THE FIELD AND CONNECTION TO SECURITY CAMERA IN THE FIELD. CONTRCTOR SHALL PROVIDE CUSTOM MOUNTING BRAKET FROM WE-EF, MODEL NUMBER NSPR1507 FOR CONNECTION TO NEW LIGHT FIXTURE. 9 NOT USED. REV # DESCRIPTION DATE #307 RFI 11.05.2025 #335 RFI 12.30.2025 #335 RFI #335 RFI