Laserfiche WebLink
<br /> <br /> Page 76 of 111 <br /> <br />Report No.: 2410B0143SHA-001 <br /> <br />TRF No. ANSI/CAN/UL 9540A_Unit <br /> <br />Attachment 3 Arrangement of the unit <br /> <br />The installation information was provided by the client as below. <br /> <br />Intended use location ................. : Residential Non-residential <br /> Non-residential rooftop <br /> Non-residential open garage use <br />Type of installation ..................... : Indoor Outdoor <br /> Floor/ground mounted Wall mounted <br />Remark: If the unit was tested without a container. Which may be <br />installed in a container for outdoor use. <br />Row(s) of installation Single Multiple <br /> <br />Three instrumented walls (wall A, wall B and wall C) with 3.66 m height and maximum 5.4m width form a <br />right angle. Walls were constructed with 16-mm gypsum wall board installed on wood studs and painted flat <br />black. <br /> <br />Two units were used for the purpose of the test. The unit adjacent to the corner of two walls was defined as <br />initiating unit. Target unit was installed on right side of the initiating unit. Two more instrumented walls were <br />used to represented for target units on other two sides of the initiating unit. This testing is therefore <br />representative for and includes the configuration with one E6160 plus one B160 on the other side of the <br />initiating unit represented by a wall with thermocouples in this test. <br /> <br />The top view of the units’ arrangement is shown in below figure. <br /> <br /> Units’ arrangement (top view) <br /> <br />Minimum separation distance between units and walls was declared by the manufacturer listed in the <br />following table. <br /> <br />Separation distances from the initiating BESS unit to <br />target walls (cm) ....................................................... : <br />A: 10 <br />B: 10 C: 10 E: 10 <br />F: 10 <br />Separation distances from the initiating BESS unit to <br />target BESS units (cm) ............................................. : D: 10 <br />The wall horizontally extended beyond the exterior <br />of the target BESS units (cm) ................................... : I: 49 (≥49cm)