Laserfiche WebLink
NOTE: <br />TURN TRAP <br />PRIMER DRAIN <br />LINE INTO WALL <br />ALL EXPOSED <br />PIPING SHALL <br />BE CHROME <br />PLATED <br />FLOOR DRAIN WITH <br />TRAP PRIMER <br />CONNECTION <br />TYPE 'K' COPPER <br />TUBING - NO JOINTS <br />BELOW FLOOR <br />SINK, EQUIPMENT OR <br />RESTROOM LAVATORY <br />COLD WATER <br />KEEP <br />MINIMUM <br />STOP VALVE <br />TRAP PRIMER WITH <br />CHROME FINISH PPP# <br />PRO1-ULP500 WITH DU-4 <br />TRAP PRIMER PIPING DETAIL <br />1/2" <br />SCALE: NONE <br />SPOUT BRACE <br />36 <br />" <br /> <br />A <br />F <br />F <br />H C <br />DRAIN <br />MOP SINK (MS-1) <br />36" HOSE <br />HOSE HOOK TO BE INSTALLED <br />AT A HEIGHT 2" LESS THAN <br />FAUCET OUTLET AND SHALL BE <br />POSITIONED TO DRAIN INTO <br />MOP SINK <br />H C <br />HOSE HOOK TO BE <br />INSTALLED AT A <br />HEIGHT 2" LESS THAN <br />FAUCET OUTLET <br />44" AFF <br />SPOUT WITH HOSE <br />END AND <br />PAILHOOK <br />SERVICE FAUCET <br />WITH VACUUM <br />BREAKER <br />4'-0" <br />EQ. <br />EQ. <br />EXISTING SLAB <br />NEW SLAB <br />POUR-BACK - <br />12" SLOPE <br />FROM EDGE <br />OF SAW CUT <br />TO DRAIN <br />FLOOR DRAIN <br />LINE OF <br />SLOPE - <br />TYP. <br />12" SLOPE <br />4'-0" <br />EQ.EQ. <br />NEW SLAB <br />POUR-BACK - 12" <br />SLOPE FROM <br />EDGE OF SAW CUT <br />TO DRAIN <br />2'-0"2'-0" <br />4'-0" SQ. <br />NOTE: FLOOR <br />FINISH (TILE) TO <br />BE CUT TO <br />ACCEPT SLOPE <br />POTFILLER <br />HOSE <br />MOP SINK DETAIL <br />SCALE: NONE <br />3" DIA. P-TRAP <br />SPOUT BRACE <br />SERVICE FAUCET WITH <br />VACUUM BREAKER <br />SPOUT WITH HOSE END <br />AND PAILHOOK <br />SIZE LARGER THAN PIPE. SEAL <br />PIPE SLEEVE TO BE ONE PIPE <br />MAIN SHUT-OFF BALL VALVE <br />SLEEVE TO BE PVC SCH. 40 <br />ONLY WITH APPROVED CAULKING <br />ELECTRICAL GROUNDING CONNECTION <br />FINISHED FLOOR <br />"K" COPPER, SOFT TEMPER <br />COLD WATER SERVICE TYPE <br />FLOW ABOVE SLAB (TYPICAL). <br />AND SHALL EXTEND 1/2" <br />VALVE - WATTS <br />PRESSURE REDUCING <br />NO. U5B SET 80 <br />SECURE PIPING TO WALL <br />PSI MAX <br />GRND <br />PER NEC SECTION 250 <br />OR EQUIVALENT <br />JOSAM NO. 75003 <br />ARRESTOR - <br />WATER HAMMER <br />ABOVE CEILING <br />CW PIPING TO <br />ACCESS DOOR FOR MAIN SHUT-OFF <br />HALLMANN SALES, LLC #DSC-214M 12x12 <br />4' <br />- <br />6 <br />" <br />MI <br />D <br />- <br />P <br />O <br />I <br />N <br />T <br /> <br />O <br />F <br /> <br />V <br />A <br />L <br />V <br />E <br />WATER SERVICE ENTRANCE LESS BACKFLOW DETAIL <br />SCALE: NONE <br />SUPPLY PIPING - <br />INSULATED <br />VENT PIPE <br />NOTE: <br />ALL EXPOSED PIPING, VALVES, <br />EQUIPMENT, ECT. TO BE A.D.A. <br />COMPLIANT. <br />2" WASTE, (MIN.), <br />FOR LOCATION <br />AND ROUTING <br />OF WASTE, VENT <br />& WATER PIPING <br />REF. PLANS. <br />2"x1-1/2" FOR <br />(SINKS AND <br />LAVS); SANITARY <br />TAPPED TEE. <br />ADAPTOR <br />AS NEEDED <br />A.D.A. LAVATORY <br />OFFSET, USE AS <br />REQUIRED TO <br />ACHIEVE A.D.A. <br />COMPLIANCE <br />LOCATE P-TRAP TO <br />PROVIDE FOR MIN. <br />KNEE CLEARANCE OF <br />8"(PER A.D.A.). <br />HEAVY CHROME PLATED <br />BRASS P-TRAP W/ <br />CLEANOUT PLUG AND <br />HEAVY CHROME PLATED <br />BRASS ELBOW, INSULATE <br />ALL EXPOSED SINK WASTE <br />AND WATER OUTLET <br />PIPING AND STOP VALVES, <br />AS PER SPECIFICATIONS <br />AND A.D.A. <br />DWV TRAP ADAPTOR AS <br />NEEDED. PROVIDE <br />ESCUTCHEON PLATE, (TYP. <br />AT WASTE AND WATER <br />WALL PENETRATIONS). <br />WALL <br />CONSTRUCTION <br />(REF. ARCH <br />DWG'S). <br />SUMMER POSIFIX <br />SUPPORT BRACKETS <br />OR APPROVED EQUAL <br />GRID <br />STRAINER <br />SCALE: NONE <br />TYP LAV/SINK CONNECTION DETAIL <br />ADAPTOR AND <br />CHROME PLATED <br />BRASS ESCUTCHEON <br />LAVATORY <br />SUPPLY <br />1" H&CW, SEE PLANS <br />FOR CONTINUATION <br />1-1/2" LOW PRESSURE NATURAL GAS <br />SUPPLY, SEE PLANS FOR CONTINUATION <br />1" BALL VALVE IN <br />ACCESSIBLE LOCATION <br />ASME RATED TEMPERATURE & <br />PRESSURE RELIEF VALVE. <br />EXTEND FULL-SIZED DISCHARGE <br />TO SPILL INTO MOP SINK <br />3/4" DRAIN VALVE <br />UNION (TYP X 3) <br />8" LONG CAPPED DIRT LEG <br />WALL MOUNTED WATER HEATER CONTROLLER. <br />LOCATE ON WALL NEAR WATER HEATER. <br />PROVIDE ALL CONTROL WIRING PER <br />MANUFACTURER'S RECOMMENDATIONS. <br />THERMOMETER <br />HWRP <br />VENT - SEE HVAC DWGS <br />SECURE TO WALL PER MANUFACTURER'S <br />RECOMMENDATIONS <br />1-1/2" AGA RATED GAS VALVE IN <br />ACCESSIBLE LOCATION <br />INSTANTANEOUS GAS HEATER <br />2 GALLON THERMAL <br />EXPANSION TANK WITH <br />NSF LINER. <br />1-1/2" <br />1" <br />REDUCER, LOCATE WITHIN 3" OF WATER <br />HEATER CONNECTION (TYP X 3) <br />TANKLESS GAS WATER HEATER DETAIL <br />N.T.S. <br />DRILL HOLE IN SIDE OF <br />BOX AND PROVIDE <br />SILICONE SEAL <br />AROUND PIPE <br />PENETRATION. <br />CO <br />CO <br />PROVIDE TRAP AT BOTTOM <br />OF RISER AND DISCHARGE <br />INTO FLOOR DRAIN OR <br />FLOOR SINK WITH AIR GAP <br />OF TWICE PIPE DIAMETER. <br />FLOOR SINK <br />OR HUB <br />DRAIN <br />PROVIDE CLEANOUT <br />IN TURNS AND ENDS <br />OF PIPE. <br />MAKE CONNECTION TO <br />COIL AS REQUIRED. <br />COORDINATE <br />ROUTING OF <br />DRAIN WITH <br />SHELVING IN <br />WALK-IN <br />BOX. <br />NO INSULATION ON PIPE RISER. <br />WALK-IN COOLER OR FREEZER BOX. <br />SEE FLOOR PLAN FOR RECEPTACLE LOCATION. <br />INSTALL PIPE AS HIGH AS POSSIBLE, ANCHORED TO WALL OF BOX WITH <br />SUPPORTS AT MAXIMUM SIX FOOT CENTERS. USE TYPE "M" HARD COPPER TUBE <br />AND FITTINGS WITH LEAD-FREE SOLDER JOINTS. SLOPE HORIZONTAL PIPE AT <br />MINIMUM TWO PERCENT. REFER TO LOCAL CODE FOR INDIRECT DRAIN <br />REQUIREMENTS. <br />PROVIDE 1" ELASTOMERIC INSULATION OVER HEAT <br />TRACING ON CONDENSATE LINE (FOR FREEZER BOX <br />ONLY) BY WALK IN BOX INSTALLER, (ELECTRIC HEATING <br />CABLE IS BY CONTRACTOR). <br />3/4"DX COIL <br />WALK-IN BOX CONDENSATE DRAIN <br />CW HW <br />(2 PSI PRESSURE AT POINT OF CONNECTION) <br />FULL Ø OF RTU CONNECTION <br />UNION <br />LBS TO INCHES PRV <br />RT <br />U <br />DRIP LEG <br />GAS COCK <br />PRESSURE TAPS, MIN. 10 PIPE DIAMETERS <br />SCALE: NONE <br />GAS EQUIPMENT CONNECTON DETAIL <br />SCALE: NONE <br />GREASE INTERCEPTOR <br />SCALE: NONE <br />P-300 <br />PLUMBING DETAILS <br />79 <br />6 <br /> <br />M <br />e <br />r <br />u <br />s <br /> <br />C <br />o <br />u <br />r <br />t <br />St <br />. <br /> <br />L <br />o <br />u <br />i <br />s <br />, <br /> <br />M <br />O <br /> <br />6 <br />3 <br />0 <br />2 <br />6 <br />T <br />6 <br />3 <br />6 <br />. <br />3 <br />4 <br />9 <br />. <br />1 <br />6 <br />0 <br />0 <br />F <br />6 <br />3 <br />6 <br />. <br />3 <br />4 <br />9 <br />. <br />1 <br />7 <br />3 <br />0 <br />16842136571210911141315 <br />84213657 1210911 1413 15 16 <br />a <br />b <br />c <br />d <br />e <br />f <br />g <br />h <br />j <br />k <br />l <br />m <br />n <br />p <br />r <br />s <br />a <br />b <br />c <br />d <br />e <br />f <br />g <br />h <br />j <br />k <br />l <br />m <br />n <br />p <br />r <br />s <br />Checked by <br />Drawn by <br />Issue Date <br />Project # <br />Scale <br />Client Approval <br />TI <br /> <br />T <br />E <br />M <br />P <br />L <br />A <br />T <br />E <br /> <br />V <br />1 <br />. <br />0 <br />, <br />10 <br />- <br />1 <br />1 <br />- <br />2 <br />0 <br />1 <br />1 <br />SANTA ANA - SOUTH <br />(#0972) <br />3313 S. BRISTOL ST. <br />SANTA ANA, CA 92704 <br />AS INDICATED <br />07/09/2025 <br />69325-CA03 <br />ISSUED FOR <br />PERMIT <br />#Description Date <br />These drawings/specifications are the property of Oculus Inc. They are <br />furnished as contract documents only. The seal(s) and signature(s) apply <br />only to the document to which they are affixed, and expressly disclaim <br />any responsibility for all other plans, specifications, estimates, reports or <br />other documents or instruments relating to or intended to be used for any <br />part or parts of the architectural or engineering project. Additionally these <br />drawings and seal(s) shall in no way convey or imply any type of warranty <br />or certification relating to the performance of products and materials <br />beyond those provided by their respective manufacturer. <br />© 2025 Oculus Inc. <br />Matthew R. Case, Engineer <br />CA # M41121 <br />HEALTH COMMENTS 10-23-20251 <br />CITY COMMENTS 01-05-20262