HomeMy WebLinkAbout148869_1_Corrections.docxRESIDENTIAL PLAN CHECK
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
PROJECT ADDRESS:
PLAN CHECK ENGINEER:TEL:714FAX:714
647-5897
TYPE OF CONSTRUCTION:
OCCUPANCY CLASSIFICATION(S):
PLAN CHECK DATES:
REMARKS:
APPLICATION
INITIAL REVIEW
EXPIRATION
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
3.
TEL:
FAX:
VALUATION:
EMAIL:
Note: Numbers in parenthesis (unless otherwise noted) refer to code sections of the 2007 California Building Code (CBC); MC = 2007 California Mechanical Code; PC = 2007 California Plumbing Code; EC = 2007 California Electrical Code; T = Table; ICC = International Code Council.All items apply noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.To the right of each correction please indicate the sheet number and detail or note number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit corrected 3 sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only.
Drawings must be to scale and be on 18" x 24" minimum sheets.For roof covering specify:Roof coverings shall have at least a Class "C" rating. (1505)
Wood framing members, including wood sheathing, that rest on exterior foundation walls and are less than 8 inches from exposed earth, shall be of naturally durable or preservative-treated wood. (T1805.4.2, 1805.2, and 2304.11.2.2)
Provide a minimum of two No. 4 barsat top and at bottom of continuous footing. (A104.1)
Provide one hour fire – resistive construction on the back side of the addition.
At the front elevation, show if there is a garage door or it is a man door and provide the size.
Show roof plan on both existing workshop and new storage.
Show how the roof will be drained between existing workshop and new storage room.
Provide cross section detail to show how new roof is being attached to existing wall.
Verify the numbers used on rafter details on sheet A3.
Provide shear wall in lieu of removing stucco at the right side of the work shop.
Show how the interior shear wall is connected to the roof diaphragm.