HomeMy WebLinkAbout186047_2_Corrections.docxTENANT IMPROVEMENT
PLAN CHECK COMMENTS
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
10178786
PROJECT ADDRESS:
202 N Euclid St
PLAN CHECK ENGINEER:
Ahangian, KathyTEL:714
647-5812FAX:714
647-5897
TYPE OF CONSTRUCTION:
V B, SPK
OCCUPANCY CLASSIFICATION(S):
B
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
5/20/2013
INITIAL REVIEW
5/25/2013
EXPIRATION
11/16/2013
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Hai Ngo
3.
TEL:
(714)548-8486
FAX:
(714)898-9694
VALUATION:$10,000.00
EMAIL:
ngovinhhai@yahoo.com
FLOOD ZONE:A-0602320252J
APPLICABLE CODE: 2010 CALIFORNIA BUILDING CODE (CBC) WITH
CITY OF SANTA ANA AMENDMENTS
All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 2corrected sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5812 for an appointment.Please return marked up set of drawings with corrections.The applicant shall obtain clearances/approvals for the following prior to building permit issuance:
- Planning Division approval on the corrected/final set of drawings (647-5804.) Previously approved plans
should be submitted to expedite the process.
- Fire Department approval on the corrected/final sets of drawings ((714)573-6100)
- Proof of Worker’s Compensation Insurance shall be required at the time of permit issuanceOn detail 2/SD-4 providenailer for the sheathing on the top of the steel beam.On detail 3 /SD-4 and 4/SD-4 continue the plywood all the way to the 2-2xRR and show the nailing.On detail 1/SD-4 attachment of 4x 16 beam to the steel post is not clear .