HomeMy WebLinkAbout189918_1_Corrections.docxTENANT IMPROVEMENT
PLAN CHECK COMMENTS
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
10179971
PROJECT ADDRESS:
221 W Dyer Rd
PLAN CHECK ENGINEER:
Mazarji, ZacTEL:714
647-5831FAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
B
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
11/12/2013
RACKS, 7’-8” Max.
INITIAL REVIEW
2/10/2014
EXPIRATION
5/11/2014
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Sam Kashanchi
3.
TEL:
(714)475-6667
FAX:
VALUATION:$5000.00
EMAIL:
sam@cleatech.com
FLOOD ZONE:X-0602320278J
APPLICABLE CODE: 2013CALIFORNIA BUILDING CODE (CBC) WITH
CITY OF SANTA ANA AMENDMENTS
All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Resubmit 3corrected sets of plans.(When needed) Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. This review does not include mechanical, plumbing, fire sprinkler system, or electrical work. Separate plans, applications, fees, plan checks, and permits are required for mechanical, plumbing, fire sprinkler systems, and electrical work. Call 647-5800 for information.The applicant shall obtain clearances/approvals for the following prior to building permit issuance:
- Planning Division approval on the corrected/final set of drawings (647-5804.) Previously approved plans
should be submitted to expedite the process.
- Fire Department approval on the corrected/final sets of drawings (647-5839 or 647-5700)
- Public Works Agency approval (647-5039)Proof of Worker’s Compensation Insurance shall be required at the time of permit issuanceOccupancies storing, handling, using, and/or selling hazardous materials, liquids, and chemicals shall submit a list of all said materials, listing their quantities and how they relate to specific California Building Code Table items. Note on the Floor Plan, type and quantity of hazardous material in each control area/racks.Indicate material name to be stored on the racks. Additional comments may apply.Occupancies using hazardous materials are subject to special requirements. It is the applicant’s/owner’s responsibility, PRIOR TO SUBMITTAL, to make this known to the Building, Planning, or Fire Departments.When there has been a change in use or occupancy classifications, drawings shall show compliance with the CBC requirements for the new classifications. Reference CBC Section 3406. Additional comments may apply.Indicate material name and weight to be stored on the drawings. Additional comments may apply.Provide positive attachment to floor and wall for each type of rack. All drawings and supporting documents shall be prepared, stamped and signed by a California licensed architect or registered civil engineer, CBC Sections A106.1 and A106.3.4.1.Licensed California engineer to sign and stamp attachment details. Note on the drawings and submit a copy of ICC Research Report for anchor bolts and required inspection by the engineer.Note on the drawings locations and inscriptions of 50 square inch minimum size permanent plaques installed in conspicuous locations, showing the maximum permissible unit load in clear, legible print. See your structural engineer. And provide a note on the drawings to insure compliance.(When applicable) The bottom of all posts shall be furnished with bearing plates. Drive-in, drive-through, and stacker racks shall be anchored to the floor by anchor bolts capable of resisting the horizontal shear forces caused by the horizontal and vertical loads on the rack.