HomeMy WebLinkAbout185805_2_Corrections.docxRESIDENTIAL PLAN CHECK
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
10178707
PROJECT ADDRESS:
541 E Central Ave
PLAN CHECK ENGINEER:
Vo, TungTEL:714
647-5830FAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
N/A
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
5/8/2013
INITIAL REVIEW
6/11/2013
EXPIRATION
11/4/2013
RECHECKS:
1.4/16/2014
PROJECT APPLICANT CONTACT PERSON:
2.
Jaime Capilla
3.
TEL:
(323)691-0698
FAX:
VALUATION: $46,700.00
EMAIL:
capillajmc@hotmail.com
FLOOD ZONE: X-0602320278J
Note: Numbers in parenthesis (unless otherwise noted) refer to code sections of the 2010 California Residential Code (CRC); 2010 California Building Code (CBC); CMC = 2010 California Mechanical Code; CPC = 2010 California Plumbing Code; CEC = 2010 California Electrical Code; T = Table; ICC = International Code Council.All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 3corrected sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5830 for an appointment.The drawings/information submitted for Building Safety Division review is incomplete. The applicant shall, prior to resubmitting, complete all construction documents to show compliance with the 2010 California Building Standards Code with local amendments and to clearly indicate the scope of work under this building permit application. There may be additional requirements when complete construction drawings and supporting data is submitted for Building Safety Division review.
Please see corrections on submitted plans. Red marked set must be returned with revised plans. Plans resubmitted without the red markup set may result in delayed review time and additional plancheck fees.
The applicant shall obtain clearances/approvals for the following, prior to building permit issuance:
-Planning Division approval on the corrected/final set of drawings (647-5804). Previously
approved plans should be submitted to expedite the process.
-Public Works Agency approval (647-5039).
-Proof of Worker's Compensation Insurance shall be required at the time of permit issuance.
Correction is ready to pick up at the counter. Please see additional corrections on plan and calculation. Additional corrections may follow when revised plan resubmitted.
4/16/14
Please show on the drawings ,
-Occupancy classification
-Area tabulation justifying floor area
- Number, width of the yard required
-classroom Sf.
-overhang Sf.
New patio cover sf
Parish hall
If building is sprinklered
Show floor plan for class room to verify exit access, and number of required exits.
Please fill out attached disabled compliance form.
Show the parking is in compliance with disabled access.
Provide path of travel to the altered area.
It is the project designer’s responsibility to show compliance on the drawings with all applicable federal and state accessibility standards.
Provide detail 1/D-1 and 2/D-2 for all the king posts per calculation
Applicant shall obtain clearances /approval from following departments:
-OCFA
-PW
-School district