HomeMy WebLinkAbout205592_1_Corrections.docxTENANT IMPROVEMENT
PLAN CHECK COMMENTS
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
10185048
PROJECT ADDRESS:
4222 W Fifth St
PLAN CHECK ENGINEER:
So, AnsonTEL:714
647-5830FAX:714
647-5897
TYPE OF CONSTRUCTION:
N/A
OCCUPANCY CLASSIFICATION(S):
N/A
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
5/12/2015
INITIAL REVIEW
6/8/2015
EXPIRATION
11/8/2015
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Claudia Fernandez
3.
TEL:
(949)916-3800257
FAX:
VALUATION:$15,000.00
EMAIL:
cfernandez@cvc-inc.net
FLOOD ZONE:A-0602320256J
APPLICABLE CODE: 2013 CALIFORNIA BUILDING CODE (CBC) WITH
CITY OF SANTA ANA AMENDMENTS
All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 2corrected sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5830 for an appointment.Please return marked up set of drawings with corrections.Sheets “CS-0.01”: Sheet “LC2.01, LC5.01, LC5.03 through LL1.01” are missing on the plan under sheet index. Revise sheet index or provide sheets“LC2.01, LC5.01, LC5.03 through LL1.01”.Sheet “CS-0.01”: Provide “Scope of Work” on the title sheet. Planning division has approved “Entry gate” on the title sheet. However, plan shows trash enclosures, shade structure, fence walls and pilaster wall details. Sheet “LC-0.01”: Wall schedule cross references details “1/ LC-5.01 and 2/LC-5.01”. However, sheet LC-5.01 is missing on the plan.Sheet “LC-1.01”: The pedestrian gates are required to be accessible. Specify the clear width, maneuvering clearances for the push and pull sides, ground surface slope, threshold, hardware type and height, closing speed, opening force and gate surface. See 2013 CBC Section 11B-404 for detailed specifications.Sheet “LS1”: Remove details not within the scope of work on the permit. Provide structural calculations for gate footing design.