HomeMy WebLinkAbout205399_2_Corrections.docxRESIDENTIAL PLAN CHECK
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
10184976
PROJECT ADDRESS:
2134 W Seventh St
PLAN CHECK ENGINEER:
Ahangian, KathyTEL:714
647-5812FAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
U
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
5/5/2015
INITIAL REVIEW
5/19/2015
EXPIRATION
11/1/2015
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Hai Ngo, Designer
3.
TEL:
(714)548-8486
FAX:
(714)898-9694
VALUATION: $50,000.00
EMAIL:
Ngovinhhai@yahoo.com
FLOOD ZONE: X-0602320144J
Note: Numbers in parenthesis (unless otherwise noted) refer to code sections of the 2013 California Residential Code (CRC); 2013 California Building Code (CBC); CMC = 2013 California Mechanical Code; CPC = 2013 California Plumbing Code; CEC = 2013 California Electrical Code; T = Table; ICC = International Code Council.All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 3corrected sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5812 for an appointment.
Please see corrections on submitted plans. Red marked set must be returned with revised plans. Plans resubmitted without the red markup set may result in delayed review time and additional plancheck fees.
This review does not include mechanical, plumbing or electrical work. Separate plans, applications, fees, plan checks, and permits are required for mechanical, plumbing, and electrical work. Call 647-5800 for information.
The applicant shall obtain clearances/approvals for the following, prior to building permit issuance:
-Planning Division approval on the corrected/final set of drawings (647-5804). Previously
approved plans should be submitted to expedite the process.
- Proof of Worker's Compensation Insurance shall be required at the time of permit issuance.
-Police Department approval on the corrected/final set of drawings.
Call out anchor bolt size and spacing on foundation plan, 1 / 2 “diameter, 7” embedment at 6’ O.C .on detail 17/D1.
Specify the header size at door, window over 4 feet opening.
Detail8/ D1 is missing.
On detail 1/D1 provide bracing to prevent hinges.
Provide carbon monoxide and smoke alarm in the following locations;
In each sleeping room.
Outside each separate sleeping area in the immediate vicinity of the bedrooms.