HomeMy WebLinkAbout207722_1_Corrections.docxTENANT IMPROVEMENT
PLAN CHECK COMMENTS
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
10185788
PROJECT ADDRESS:
1528 Brookhollow Dr Unit# 400
PLAN CHECK ENGINEER:
Mazarji, ZacTEL:714
647-5831FAX:714
647-5897
TYPE OF CONSTRUCTION:
V B (SPK under a separate permit)***
OCCUPANCY CLASSIFICATION(S):
B
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
7/20/2015
*** to be verified by applicant
INITIAL REVIEW
8/18/2015
Two story Ti
EXPIRATION
1/16/2016
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Heather Rhinehart
3.
TEL:
(949)679-6880
FAX:
VALUATION:$214,825.00
EMAIL:
heater@cascocontractors.com
FLOOD ZONE:X-0602320278J
APPLICABLE CODE: 2013 CALIFORNIA BUILDING CODE (CBC) WITH
CITY OF SANTA ANA AMENDMENTSResubmit 3corrected sets of plans.Please refer to red mark drawings for applicable plan check comments.Return marked up set of drawings with 3 corrected sets.(When needed) Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5831 for an appointment.Please return marked up set of drawings with corrections.The applicant shall obtain clearances/approvals for the following prior to building permit issuance:
- Planning Division approval on the corrected/final set of drawings (647-5804.) Previously approved plans
should be submitted to expedite the process.
- Fire Department approval on the corrected/final sets of drawings (647-5839 or 647-5700)
- Police Department approval on the corrected/final set of drawings (647-5840)
- Public Works Agency approval (647-5039)
- Proof of Worker’s Compensation Insurance shall be required at the time of permit issuancePlease clarify if Sprinklered system is proposed to be installed as part of this permit on the drawings. If applicable note on the drawings, Sprinklered permit is a deferred submittal.Refer to attached handout for 2013 GalGreen and SB 407 and provide a completed form attached to drawings to insure compliance.