Loading...
HomeMy WebLinkAbout210408_2_Corrections.docxTENANT IMPROVEMENT PLAN CHECK COMMENTS COMMENTS Planning & Building Agency Building Safety Division 20 Civic Center Plaza P.O. Box 1988 (M-19) Santa Ana, CA 92702 (714) 647-5800 www.santa-ana.org PLAN CHECK NO: 10186689 & 10186760 PROJECT ADDRESS: 5 E Hutton Center Dr PLAN CHECK ENGINEER: Heidari, FredTEL:714 647-5862FAX:714 647-5897 TYPE OF CONSTRUCTION: N/A OCCUPANCY CLASSIFICATION(S): U PLAN CHECK DATES: REMARKS/RECHECK ITEMS: APPLICATION 9/29/2015 INITIAL REVIEW 10/21/2015 EXPIRATION 3/27/2016 RECHECKS: 1. PROJECT APPLICANT CONTACT PERSON: 2. Jared Bohonus 3. TEL: (949)387-132331 FAX: VALUATION:$54,556.00 EMAIL: Jared@ridgela.com FLOOD ZONE:X-0602320278J APPLICABLE CODE: 2013 CALIFORNIA BUILDING CODE (CBC) WITH CITY OF SANTA ANA AMENDMENTSPlease indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 3corrected sets of plans.The drawings/information submitted for Building Safety Division review is incomplete. The applicant shall, prior to resubmitting, complete all construction documents to show compliance with the 2013 California Building Standards Code with local amendments.This review does not include plumbing or electrical work. Separate plans, applications, fees, plan checks, and permits are required for plumbing and electrical work. Call 647-5800 for information.The applicant shall obtain clearances/approvals for the following prior to building permit issuance: - Planning Division approval on the corrected/final set of drawings (647-5804.) Previously approved plans should be submitted to expedite the process. - Fire Department approval on the corrected/final sets of drawings ((714)573-6100) - Public Works Agency approval (647-5039) - Proof of Worker’s Compensation Insurance shall be required at the time of permit issuanceIf a walk crosses or adjoins a vehicular way, and the walking surfaces are not separated by curbs, railings or other elements between the pedestrian areas and vehicular areas, the boundary between the areas shall be defined by a continuous detectable warning which is 36” wide, complying with the CBC Section 11B-705. Detectable Warning Product Approval. Only approved Division of the State Architect, Access Compliance (DSA/AC) approved detectable warning products and directional surfaces shall be installed in accordance with CBC Section 11B-705.Provide information on these plans to confirm that pre-cast truncated dome pavers shown on sheet L0.2 comply with requirements of CBC Section 11B-705.The following sheets of this set of plans are marked as: “FOR REFERNCE ONLY”. Sheets L1.1, L2.1, L2.2, L3.1, L3.2, & L4.1. However, there is information on these sheets that may be part of this permit. Please review these sheets and make sure that they are not relevant to this permit. The plan check # 10186760 is submitted with this plansfor demoing the “CANOPY STRUCTURE”. Please show the location of this canopy structure on the site plan with all the relevant information. The light pole base shown on sheet L4.1, detail “H”, shall be deleted since detail B/L0.2 is the engineered detail for this job.