HomeMy WebLinkAbout214253_1_Corrections.docxRESIDENTIAL PLAN CHECK
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
10288018
PROJECT ADDRESS:
2206 S Maple St
PLAN CHECK ENGINEER:
Chehade, NabilTEL:714
647-5848FAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
R-3, U
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
1/28/2016
INITIAL REVIEW
3/21/2016
EXPIRATION
7/26/2016
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Francisco Escobar
3.
TEL:
(714)222-3674
FAX:
VALUATION:$9,543.90
EMAIL:
FLOOD ZONE:X-0602320278J
Note: Numbers in parenthesis (unless otherwise noted) refer to code sections of the 2007 California Building Code (CBC); MC = 2007 California Mechanical Code; PC = 2007 California Plumbing Code; EC = 2007 California Electrical Code; T = Table; ICC = International Code Council.All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit corrected sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5848 for an appointment.All persons preparing plans for others shall sign those plans. Business and Professions Code Chapter 3, Division 3, Section 5536.1 (a).
Provide an Index of drawings on cover sheet.
Exterior walls of detached garage/carport less than 5 feet from property line shall have one-hour fire-resistive construction on the exterior side with openings complying with 704.
Projections, including eaves, shall be of one-hour fire-resistive construction, heavy timber or of noncombustible material if they are less than 3’-4” from a side or rear property line. (704, T704.8)Dimension roof overhangs showing compliance with CBC Section 704.For roof covering specify:
-Manufacturer and type of built-up roof. (1506)
-Roof slope(s) of all areas on the roof plan. (1507)
-Type/manufacturer and International Code Conference (ICC)/Underwriters Laboratories (UL)
number of shingle/tile roof. (1506)
-Roof coverings shall have at least a Class "C" rating. (1505)
Rafter ties spaced 4 ft. (max.) on center are required immediately above ceiling joists which are not parallel to the rafters. (2308.10.4)
Provide a narrative on first sheet of plans describing the scope of work under this permit.
Clarify on plans the status of the toilet room and utility room.
Provide flashing etc. at the edge of the roof where no eve is provided to prevent water intrusion.
Provide a framing and foundation plan for the patio cover, show sizes of all memebers.
Show the size of the ridge board one size larger than the rafters.
Provide dimensions for the patio.
Show location of carbon monoxide.
The smoke detector legend shown on the plans is different than the legend shown in the electrical notes.