HomeMy WebLinkAbout224914_1_Corrections.docxTENANT IMPROVEMENT
PLAN CHECK COMMENTS
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
10191412
PROJECT ADDRESS:
1807 N Main St
PLAN CHECK ENGINEER:
Heidari, FredTEL:714
647-5862FAX:714
647-5897
TYPE OF CONSTRUCTION:
V B, SPK
OCCUPANCY CLASSIFICATION(S):
B
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
11/21/2016
INITIAL REVIEW
12/8/2016
EXPIRATION
5/20/2017
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Donnie DeWees
3.
TEL:
(714)850-7575
FAX:
VALUATION:$168,701.00
EMAIL:
ddewees@bundyfinkel.com
FLOOD ZONE:X-0602320163J
APPLICABLE CODE: 2013 CALIFORNIA BUILDING CODE (CBC) WITH
CITY OF SANTA ANA AMENDMENTS
All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 2corrected sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5862 for an appointment.The drawings/information submitted for Building Safety Division review is incomplete. The applicant shall, prior to resubmitting, complete all construction documents to show compliance with the 2013 California Building Standards Code with local amendments.All drawings and supporting documents shall be prepared, stamped and signed by a California licensed architect or registered civil engineer.The applicant shall obtain clearances/approvals for the following prior to building permit issuance:
- Planning Division approval on the corrected/final set of drawings (647-5804.) Previously approved plans
should be submitted to expedite the process.
- Public Works Agency approval (647-5039)
- Proof of Worker’s Compensation Insurance shall be required at the time of permit issuanceProvide the following:
- Provide a fully dimensioned site plan on each set of plans.
- Disabled access compliance must be shown on the site plan.
- provide a foundation plan and show the locations, dimensions, specifications, details, and other information for these: “A1 Arch Frame Footings”. Also, indicate the spacing for the canopy support.Show on the plans:
- Occupancy Classification(s)
- Type of Construction
- Fire Sprinkler System It is the project designer’s/property owner’s responsibility to show compliance on the drawings with all applicable Federal and State Accessibility Standards.Provide structural calculations and drawings, stamped and signed by a California licensed architect or registered civil engineer for:
- Structural support for these canopies.
- provide spec. for the Canopy fabric and justify what does it mean “FABRIC VERY POROUS TO WIND”? I think a percentage of the fabric area shall be taken to resist the wind loads and the calculation shall take that area into the design of lateral load of the canopy support.
- Submit calculation for anchor bolt design to support the loads of the canopy column.