HomeMy WebLinkAbout232429_2_Corrections.docxRESIDENTIAL PLAN CHECK
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
10193617
PROJECT ADDRESS:
541 W Santa Clara Ave
PLAN CHECK ENGINEER:
Heidari, FredTEL:714
647-5862FAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
R-3, U
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
7/25/2017
INITIAL REVIEW
9/6/2017
EXPIRATION
1/21/2018
RECHECKS:
1. 12/18/2017
PROJECT APPLICANT CONTACT PERSON:
2.
Matthew White
3.
TEL:
(406)579-5384
FAX:
VALUATION:$10,000.00
EMAIL:
mwhite_145@hotmail.com
FLOOD ZONE:X-0602320163J
The recheck of your drawing was completed this morning, 12/18/2017; and your drawing was approved for building permit issuance subject to item # 8 listed below.
The approved plans are placed at the plan check counter for your convenience.All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 2corrected sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5862 for an appointment.The drawings/information submitted for Building Safety Division review is incomplete. The applicant shall, prior to resubmitting, complete all construction documents to show compliance with the 2016 California Building Standards Code with local amendments and to clearly indicate the scope of work under this building permit application. There may be additional requirements when complete construction drawings and supporting data is submitted for Building Safety Division review.
All drawings and supporting documents shall be prepared, stamped, and signed by a California licensed architect or registered engineer.
This review does not include mechanical, plumbing or electrical work. Separate plans, applications, fees, plan checks, and permits are required for mechanical, plumbing, and electrical work. Call 647-5800 for information.
The applicant shall obtain clearances/approvals for the following, prior to building permit issuance:
-Planning Division approval on the corrected/final set of drawings (647-5804). Previously
approved plans should be submitted to expedite the process.
- Public Works Agency approval (647-5039).
- Proof of Worker's Compensation Insurance shall be required at the time of permit issuance.
Provide a fully dimensioned floor and framing plans for each level (basement, 1st, and 2nd floor) showing existing and proposed conditions and indicating the use of each room or area. On these plans clearly indicate which walls are bearing walls that will be altered/ removed.Show the location(s) of hard-wired smoke alarm(s) with a battery back up in each sleeping room and at a point centrally located in the hallway or area giving access to each sleeping area. A detector shall be located at each story and the upper level of split level stories. A detector shall be located in close proximity to the stairway when sleeping rooms are on the upper level. (Battery-operated smoke detectors are permitted in existing construction only.) Show location of carbon monoxide alarm on the drawings.
Provide full height cross sections through the building showing framing, interior/exterior sheathing, plate heights, insulation, foundation, finish grade, etc.
Show location of underfloor access crawl hole (18 x 24 inches).
The valuation for this permit application seems to be low. Please verify the valuation upon resubmittal.
Provide a clear structural calculations and drawings prepared by a California Licensed Architect or Registered Civil Engineer for all structural work to be performed under the subject building permit application. Calculation must be presented in a clear and organized manner conducive for structural plan review. A table of content must be provided with a framing plan for each level. A correlated grid system must be provided on the structural calculations and drawings to facilitate plan review process. Resubmitted revised calculations showing compliance.