HomeMy WebLinkAbout240686_2_Corrections.docxTENANT IMPROVEMENT
PLAN CHECK COMMENTS
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
10196188
PROJECT ADDRESS:
2414 N Tustin Ave
PLAN CHECK ENGINEER:
Chehade, NabilTEL:714
647-5848FAX:714
647-5897
TYPE OF CONSTRUCTION:
N/A
OCCUPANCY CLASSIFICATION(S):
N/A
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
4/19/2018
INITIAL REVIEW
5/1/2018
EXPIRATION
10/16/2018
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Ron Faulkner
3.
TEL:
(678)485-0566
FAX:
VALUATION:
EMAIL:
rfaulkner@capgro.net
FLOOD ZONE:X-0602320164J
APPLICABLE CODE: 2016CALIFORNIA BUILDING CODE (CBC) WITH
CITY OF SANTA ANA AMENDMENTS
All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 2corrected sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5848 for an appointment.This review does not include mechanical, plumbing, fire sprinkler system, or electrical work. Separate plans, applications, fees, plan checks, and permits are required for mechanical, plumbing, fire sprinkler systems, and electrical work. Call 647-5800 for information.The applicant shall obtain clearances/approvals for the following prior to building permit issuance:
- Planning Division approval on the corrected/final set of drawings (647-5804.) Previously approved plans
should be submitted to expedite the process.Ramp width is clear width with the handrail allowed to projectinto the width a maximum of 3.5 inches at the handrail height.Handrails are required on both sides of the ramp.Provide a curb barrier per section 11B-405.9.2.A clearance of 1.5 inches minimum shall be provided between the handrail griping surfaces and adjacent surfaces.Provide a section of the ramp that shows all barriers around the ramp and shows compliance with the items specified above.