HomeMy WebLinkAbout241645_3_Corrections.docxRESIDENTIAL PLAN CHECK
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
10296466
PROJECT ADDRESS:
2205 1/2 S Orange Ave
PLAN CHECK ENGINEER:
So, AnsonTEL:714
647-5830FAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
R-3
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
5/17/2018
INITIAL REVIEW
6/10/2018
EXPIRATION
11/13/2018
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Danny Rodriguez
3.
TEL:
(714)926-4389
FAX:
VALUATION: $100000.00
EMAIL:
FLOOD ZONE: X-0602320278J
INSTRUCTIONS:
Numbers in brackets refer to code sections of 2016 California Residential Code [CRC], 2016 California
Building Code [CBC], 2016 California Plumbing Code [CPC], 2016 California Mechanical Code [CMC],
2016 California Electrical Code [CEC], 2016 California Energy Code (2016 Building Energy Efficiency
Standards [BEES]), and 2016 California Green Buildings Standards Code [CalGreen]
Correct original drawings. Reprint and submit 3 new sets together with the “marked-up” set. Return this
corrections list with corrected plans.
In the Item number column, ☒ in the checkbox represents correction requested.
In the Respond column, please indicate the sheet number and detail or note number on the plan where the
corrections are made.
Itemize any changes, revisions, or additions made to drawings that are not a direct answer to a correction on a
separate sheet.Additional plan check fee will be required after third review on hourly rate basis.Plan Check CommentsSecond resubmitted plans have been reviewed. Majority of plan review notes and comments have been addressed and incorporated onto the plan. The remaining items are as follow:Provide scope of work on the title sheet:” Legalize 598 square foot accessory dwelling unit attach to the garage”. Specify existing roof and ceiling framing member size and spacing on the plan. Structural members shall be adequately safe for accessory dwelling unit.Provide an interior shear-transfer detail between interior wall and roof sheathing. Conventional framing is acceptable without Engineering calculations provided wall bracing are not longer than 25-foot apart. Provide detail to show structural connection between the roof sheathing to interior wall below the roof.