HomeMy WebLinkAbout248302_2_Corrections.docxTENANT IMPROVEMENT
PLAN CHECK COMMENTS
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
10198409
PROJECT ADDRESS:
666 E Dyer Rd
PLAN CHECK ENGINEER:
Heidari, FredTEL:714
647-5862FAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
U
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
11/20/2018
INITIAL REVIEW
12/18/2018
EXPIRATION
5/19/2019
RECHECKS:
1. 01/17/2019
PROJECT APPLICANT CONTACT PERSON:
2.
David Sloan
3.
TEL:
(714)560-8643
FAX:
VALUATION:$25,000.00
EMAIL:
dsloan@tait.com
FLOOD ZONE:X-0602320278J
The recheck of your drawings was completed this morning, 01-17-2019; and the drawing is approved for building permit issuance subject to approvals required under item # 9 from the list below.
The approved plans are placed at the plan check counter for your convenience.
CITY OF SANTA ANA AMENDMENTS
All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 2corrected sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5862 for an appointment.All drawings and supporting documents shall be prepared, stamped and signed by a California licensed architect or registered civil engineer.The submitted plans are not signed at this time.All persons preparing plans, specifications, and instruments of service for others shall sign those plans, specifications and other instruments of service for others shall sign those plans, specifications and other instruments of service and all contracts therefore. This requirement applies to both exempt and non-exempt projects. Business and Professions Code Chapter 3, Division 3, Section 5536.1(a).The application for this plan check is for 3 retaining walls. Drawing on sheet 2 call 8’ fence to be placed on top of proposed retaining wall. First, please obtain Planning approval for this 8’ fence. Second, provide construction details for attaching this fence to the proposed block retaining wall.The calculation for proposed retaining walls calls for rebars to be placed at the edge. Provide enlarge construction detail to show this condition. Also, provide construction details to show how the grade beam will be connected to pier footings at 12’ OC.The applicant shall obtain clearances/approvals for the following prior to building permit issuance:
- Planning Division approval on the corrected/final set of drawings (647-5804.) Previously approved plans
should be submitted to expedite the process.
- Orange county Fire Authority approval on the corrected/final sets of drawings ((714)573-6100)
- Public Works Agency approval (647-5039)
- Proof of Worker’s Compensation Insurance shall be required at the time of permit issuanceProvide the following:
- Provide a fully dimensioned site plan on each set of plans. Clearly show that the existing from the existing buildings on the site can reached the Public Way without being blocked by proposed retaining walls. Also, clearly show the property lines on the site plans and provide distance from the property lines to proposed retaining walls to ensure that these retaining walls are not in the Right-A-Way area.
- Disabled access compliance must be shown on the site plan.Exiting from any occupied point in a building or structure on the subject site must be continuous, unobstructed, and undiminished to a public way. This includes proposed retaining wall with 8’ fence. Show compliance with CDB chapter 10. Revise drawings to show compliance.