HomeMy WebLinkAbout250057_2_Corrections.docxSPC
PLAN CHECK COMMENTS
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
10198954
PROJECT ADDRESS:
1010 W McFadden Ave
PLAN CHECK ENGINEER:
So, AnsonTEL:714
647-5830FAX:714
647-5897
TYPE OF CONSTRUCTION:
V B, SPK
OCCUPANCY CLASSIFICATION(S):
R-3, U
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
1/22/2019
INITIAL REVIEW
3/25/2019
EXPIRATION
7/21/2019
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Steven Ezaki
3.
TEL:
(949)929-0761
FAX:
VALUATION:$19,000.00
EMAIL:
steve@freelancerdrafting.net
FLOOD ZONE:X-0602320257J
APPLICABLE CODE: 2016 CALIFORNIA BUILDING CODE (CBC) WITH
CITY OF SANTA ANA AMENDMENTS
All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 3corrected sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5830 for an appointment.All drawings and supporting documents shall be prepared, stamped and signed by a California licensed architect or registered civil engineer. CBC Sections A106.1 and A106.3.4.1.PLAN REVIEW COMMENTSOn sheet number two of the plan, plan view indicates lightweight tile as roofing material, and Left Elevation shows a roof slope of one-foot horizontal-to-3/8-inches vertical ratio. Person California Residential Code Section R905.3.2, the minimum roof slope shall be (2 ½:12) minimum. Revise roof slope as necessary.Show an existing exterior door on Plan View on sheet 2. The proposal of exterior-enclosure structure shall not eliminate the existing exterior door.Specify underlayment specification for roof tile.Show exterior landing, size, dimensions, and elevation difference between the threshold and the ground below.Provide partial floor plan where the enclosure structure is connected. Provide information such that light, ventilation and egress requirement are not compromised as described per Appendix I Section I103.2.