HomeMy WebLinkAbout256116_3_Corrections.docxTENANT IMPROVEMENT
PLAN CHECK COMMENTS
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
101100821
PROJECT ADDRESS:
1225 E Wakeham Ave
PLAN CHECK ENGINEER:
Heidari, FredTEL:714
647-5862
EMAIL:
fHeidari@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
III B
OCCUPANCY CLASSIFICATION(S):
B
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
7/19/2019
INITIAL REVIEW
7/31/2019
EXPIRATION
1/15/2020
RECHECKS:
1. 08/21/2019
PROJECT APPLICANT CONTACT PERSON:
2. 08/22/2019
Chris Kane
3.
TEL:
(949)351-2945
FAX:
VALUATION: $81,000.00
EMAIL:
ckane@ice-energy.com
FLOOD ZONE: X-0602320276J
Your drawing was approved for building permit issuance subject to approvals required under item # 8 from the list below. The approved drawings are placed at the plan check counter for your convenience.
A recheck of your drawing was completed this morning, 08-21-2019; and the following items from the first plan check list are not done/ completed at this time. See the list below for item # 6, 7, & 8. Called the structural engineer for this project, ED NAJJARINE, and left a message this morning.
APPLICABLE CODE: 2016 CALIFORNIA BUILDING CODE (CBC) WITH
CITY OF SANTA ANA AMENDMENTS
All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 2corrected sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5862 for an appointment.The drawings/information submitted for Building Safety Division review is incomplete. The applicant shall, prior to resubmitting, complete all construction documents to show compliance with the 2016 California Building Standards Code with local amendments.Provide structural calculations and drawings, stamped and signed by a California licensed architect or registered civil engineer for:
- New equipment screening on roof if it is required by Planning Division. - The drawings shall clearly show framing members under these 5500 # “Ice Bear” units and show how VERTICAL AND LATERAL LOADS will be distributed to existing roof framing members. (Any proposed reinforcement of existing 2 X 4 @ 24” O.C. under these Ice Bear unitsThis review does not include mechanical, plumbing, or electrical work. Separate plans, applications, fees, plan checks, and permits are required for mechanical, plumbing, and electrical work. Call 647-5800 for information.The applicant shall obtain clearances/approvals for the following prior to building permit issuance:
- Planning Division approval on the corrected/final set of drawings (647-5804.) Previously approved plans
should be submitted to expedite the process.
- Public Works Agency approval (647-5039)
- Proof of Worker’s Compensation Insurance shall be required at the time of permit issuance