HomeMy WebLinkAbout269721_3_Corrections.docxRESIDENTIAL PLAN CHECK
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
102105088
PROJECT ADDRESS:
215 1/2 E Chestnut Ave
PLAN CHECK ENGINEER:
Le, TungTEL:714
647-5894
EMAIL:
Tle10@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
R-3, U
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
10/28/2020
INITIAL REVIEW
11/6/2020
EXPIRATION
4/26/2021
RECHECKS:
1.12/2/2020
PROJECT APPLICANT CONTACT PERSON:
2.
Juan Pomalaza
3.
TEL:
(949)742-2395
FAX:
(714)866-4164
VALUATION: $30,000.00
EMAIL:
juancapomalaza@gmail.com
FLOOD ZONE: X-0602320276J
Note: Numbers in parenthesis (unless otherwise noted) refer to code sections of the 2019 California Residential Code (CRC); 2019 California Building Code (CBC); CMC = 2019 California Mechanical Code; CPC = 2019 California Plumbing Code; CEC = 2019 California Electrical Code; T = Table; ICC = International Code Council.All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 3corrected sets of plans.
The applicant shall obtain clearances/approvals for the following, prior to building permit issuance:
Planning Division approval on the corrected/final set of drawings (647-5804). Previously
approved plans should be submitted to expedite the process.
Police Department approval on the corrected/final set of drawings (647-5840).
Public Works Agency approval (647-5039).
School District
Structural Comments:
Detail 15/S3 called out at the interior structural wall was not applicable. Please provide detail to show ceiling and roof rafter run perpendicular to wall.
2nd Review Comment: Detail 15/S3, Shear Transfer detail – Please revise detail to show roof rafter run perpendicular with wall (not parallel as shown).