HomeMy WebLinkAbout269990_2_Corrections.docxRESIDENTIAL PLAN CHECK
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
101105158
PROJECT ADDRESS:
323 E Buffalo Ave
PLAN CHECK ENGINEER:
Le, TungTEL:714
647-5896
EMAIL:
Tle10@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
R-3, U
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
11/6/2020
INITIAL REVIEW
12/10/2020
EXPIRATION
5/5/2021
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Cynthia Zanabria
3.
TEL:
(714)326-7479
FAX:
VALUATION: $40,554.00
EMAIL:
hernandezcynthia789@gmail.com
FLOOD ZONE: X-0602320163J
Note: Numbers in parenthesis (unless otherwise noted) refer to code sections of the 2019 California Residential Code (CRC); 2019 California Building Code (CBC); CMC = 2019 California Mechanical Code; CPC = 2019 California Plumbing Code; CEC = 2019 California Electrical Code; T = Table; ICC = International Code Council.General and InstructionAll items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 3corrected sets of plans.The drawings/information submitted for Building Safety Division review is incomplete. The applicant shall, prior to resubmitting, complete all construction documents to show compliance with the 2010 California Building Standards Code with local amendments and to clearly indicate the scope of work under this building permit application. There may be additional requirements when complete construction drawings and supporting data is submitted for Building Safety Division review.
The applicant shall obtain clearances/approvals for the following, prior to building permit issuance:
-Planning Division approval on the corrected/final set of drawings (647-5804). Previously
approved plans should be submitted to expedite the process.
-Police Department approval on the corrected/final set of drawings (647-5840).
-Public Works Agency approval (647-5039).
- Proof of Worker's Compensation Insurance shall be required at the time of permit issuance.
Sheet A1:
Site plan: Please show area of addition at the family expansion.
Governing Code: Please specify 2019 California Energy Code.
Sheet A4:
Exterior wall located less than 5-ft from the property line shall be constructed with one-hour fire-rated wall. On the plan, please show one-hour wall and provide construction detail. Clearly cross-reference detail onto the plan.
Please show/provide door landing at door D01 and D03. Landing shall be minimum 36” measured in the direction of travel, and width equal to door opening. Landing shall not be more than 73/4 inches (196 mm) below the top of the threshold.
Please specify tempered glass for glazing in door (door D03).
Sheet A6:
Section B-B: Please revise section to show wall insulation of R-15 and floor insulation of R-19.
On the plan, please specify maximum dimension of roof eave overhang. Eave shall not project into the 2-ft fire separation distance.
Eave project: Please provide one-hour fire protection on the underside of eave. Except, eave with solid fire-block, one-hour projection on the underside may not be required. Provide detail and clearly cross-reference detail onto the plan.
Sheet A7:
Receptacle outlets provided at kitchen island shall be protected with GFCI.
Please note on plan: Electrical, Mechanical and Plumbing were not part of this plan approval and are subject to field inspection.
Structural Comments:
Roof framing: Please provide detail section at ceiling beam 1 to show support of existing roof framings.
Provide detail to show beam 1 to beam 2.
Detail 26/D2: Please revise detail to provide minimum 8” heightconcrete curb.
Detail 25/D2: Please revise detail to provide 8” height concrete curb.