HomeMy WebLinkAbout274171_1_Corrections.docxTENANT IMPROVEMENT
PLAN CHECK COMMENTS
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
101106417
PROJECT ADDRESS:
1995 S Standard Ave
PLAN CHECK ENGINEER:
So, AnsonTEL:714
647-5830
EMAIL:
aso@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
III B, SPK
OCCUPANCY CLASSIFICATION(S):
B, H-3, S-1
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
4/13/2021
INITIAL REVIEW
4/24/2021
EXPIRATION
10/10/2021
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Carrie Sharifi
3.
TEL:
(626)384-0481
FAX:
VALUATION: $152,000.00
EMAIL:
carriesharif@yahoo.com
FLOOD ZONE: X-0602320276J
APPLICABLE CODE: 2019 CALIFORNIA BUILDING CODE (CBC) WITH
CITY OF SANTA ANA AMENDMENTS
All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 2corrected sets of plans.Title SheetHighlight location of the proposed storage racks on the site plan. It appears only a partial floor plan has been provided on sheet RH3.0.Show on plans a complete description of the entire scope of work. The building permit application states:” Installation of storage racks at 9.5 feet.” On sheet SED, the height of storage racks is 25 feet. The final set of plans must be approved and stamped by the Orange County Fire Department.Sheet RH3.0Revise note to “Floor Plan” on the drawing. This is not an elevation drawing.Identify storage rack type A or B on the floor plan.Lower portions of posts exposed to damage by forklift trucks or other moving equipment shall have two possible ways to safeguard racks against the consequences of minor collisions: 1) provide protective devices, 2) reinforce the bottom portion of the front column and/or bracing (RMI 1.4.9 Commentary)