HomeMy WebLinkAbout269354_2_Corrections.docxRESIDENTIAL PLAN CHECK
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
101104971
PROJECT ADDRESS:
1325 1/2 N Custer St
PLAN CHECK ENGINEER:
Le, TungTEL:714
647-5896
EMAIL:
Tle10@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
R-3
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
10/15/2020
INITIAL REVIEW
11/5/2020
EXPIRATION
4/13/2021
RECHECKS:
1.6/3/2021
PROJECT APPLICANT CONTACT PERSON:
2.
Catie Vuong
3.
TEL:
(714)260-4994
FAX:
VALUATION: $120,000.00
EMAIL:
catievuong@gmail.com
FLOOD ZONE: X-0602320163J
Note: Numbers in parenthesis (unless otherwise noted) refer to code sections of the 2019 California Residential Code (CRC); 2019 California Building Code (CBC); CMC = 2019 California Mechanical Code; CPC = 2019 California Plumbing Code; CEC = 2019 California Electrical Code; T = Table; ICC = International Code Council.General and Approval RequirementAll items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 3corrected sets of plans.
The applicant shall obtain clearances/approvals for the following, prior to building permit issuance:
-Planning Division approval on the corrected/final set of drawings (647-5804). Previously
approved plans should be submitted to expedite the process.
-Police Department approval on the corrected/final set of drawings (647-5840).
-Public Works Agency approval (647-5039).
- School District Compliance Certificate; and a copy of the building permit application, signed by
the plan check engineer, shall be required by the School District to verify the scope of the work.
-Grading Permit. Application is made through the Building Safety Division (647-5800) and the
plan review is by the Public Works Agency (647-5039).
Sheet A0.1:
Exterior wall located within 5-ft of the fire separation distance shall be protected with one-hour fire-rated wall. Please specify one-hour wall on plan, and provide construction detail of one-hour wall assembly. Clearly cross-reference detail onto the plan.
2nd Review Comment: Response was incomplete. Please revise floor plan to show one-hour fire-rated wall and provide construction detail for one-hour fire-rated wall assembly.
Exterior wall located within 5-ft of the fire separation distance: Wall openings shall not exceed 25% of wall.
Revise plan to provide 2x6 wall to accommodate R-21 wall insulation, per Title 24 calculation.
2nd Review Comment: Please provide wall legend for the 2x6 exterior wall stud.
Sheet A2.1A2.0:
Please revise window openings and type to match with Window Schedule (slider).
2nd Review Comment: Please revise elevation to show sliding window (match with window schedule).
Sheet A2.2 A2.1:
Building Section: Please specify R-21 insulation for wall as required by the Title 24 calculation.
2nd Review Comment: Please revise Section Keynote#5 to provide 2x6 wall studs at 16” on center.
Structural Comments:
Please coordinate with architectural plan for wall thickness (2x6 wall studs). Coordinate and revise plans and details accordingly.
2nd Review Comment: 2x6 stud walls are required for the exterior walls. Please revise plan to show 2x6 wall studs with 6x headers.
Sheet S.1: Slab shall be minimum 5” thick per soil report, please revise slab specification.
2nd Review Comment: Please revise footing details on sheet SD.1 to specify 5” thick concrete slab with #4 rebar at 18” on center.
Structural calculation shall be stamped, signed, and dated by the engineer of record.