HomeMy WebLinkAbout272549_2_Corrections.docxRESIDENTIAL PLAN CHECK
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
101105908
PROJECT ADDRESS:
2926 1/2 W La Verne Ave
PLAN CHECK ENGINEER:
Le, TungTEL:714
647-5896
EMAIL:
Tle10@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
R-3
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
2/18/2021
INITIAL REVIEW
3/15/2021
EXPIRATION
8/17/2021
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Edgar Linares
3.
TEL:
(714)866-8785
FAX:
VALUATION: $30,000.00
EMAIL:
esvett17@gmail.com
FLOOD ZONE: X-0602320256J
Note: Numbers in parenthesis (unless otherwise noted) refer to code sections of the 2019 California Residential Code (CRC); 2019 California Building Code (CBC); CMC = 2019 California Mechanical Code; CPC = 2019 California Plumbing Code; CEC = 2019 California Electrical Code; T = Table; ICC = International Code Council.All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 3corrected sets of plans.
The applicant shall obtain clearances/approvals for the following, prior to building permit issuance:
-Planning Division approval on the corrected/final set of drawings (647-5804). Previously
approved plans should be submitted to expedite the process.
-Police Department approval on the corrected/final set of drawings (647-5840).
-Public Works Agency approval (647-5039).
- School District Compliance Certificate; and a copy of the building permit application, signed by
the plan check engineer, shall be required by the School District to verify the scope of the work.
Sheet A-1:
Please note on plan: Mechanical, Electrical and Plumbing are not part of this plan review and approval. MEP are subject to field inspection.
West (rightside) wall of the ADU located less than 5-ft from the property line shall be protected with one-hour fire-rated construction. Please provide/show minimum 5/8” type ‘X’ gypsum board on the inside of wall, extended from foundation to the underside of the roof sheathing.
Door at the fire-rated wall shall be minimum 20-minute fire-rated door with self-closing.
Wall between existing house and ADU: Wall separating two living units shall be protected with one-hour fire-rated wall. Please show one-hour wall and provide detail construction of one-hour fire-rated wall assembly. 5/8” gypsum board shall be required on both sides of the wall. Detail shall be clearly cross-referenced onto the plan.
Section AA called out on the floor plan – please revise section callout to sheet A-2.
Please show minimum 3-ft level landing, measured on the direction of travel, on both side of the door.
Provide attic access with minimum 30” clear headroom.
Sheet A-2:
Section AA: Please revise section to provide fire-blocking at eave; otherwise, provide one-hour protection on the underside of the projection.
On the plan, please show/provide attic vents for attic space over the proposed ADU.
Sheet S-1:
Roof framing Plan: Please clarify ceiling joists showed at the hip lines. Should it be roof rafters?