HomeMy WebLinkAbout279065_2_Corrections.docxTENANT IMPROVEMENT
PLAN CHECK COMMENTS
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
101107862
PROJECT ADDRESS:
2000 E Seventeenth St Unit# MTR01
PLAN CHECK ENGINEER:
Lee, WayneTEL:714
647-5848
EMAIL:
wlee@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
N/A
OCCUPANCY CLASSIFICATION(S):
N/A
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
9/2/2021
INITIAL REVIEW
9/11/2021
EXPIRATION
3/1/2022
RECHECKS:
1.9/25/2021
PROJECT APPLICANT CONTACT PERSON:
2.
Doug Walkup
3.
TEL:
(714)697-3494
FAX:
VALUATION: $700,000.00
EMAIL:
dwalkup@brytemove.com
FLOOD ZONE: X-0602320164J
APPLICABLE CODE: 2019 CALIFORNIA BUILDING CODE (CBC) WITH
CITY OF SANTA ANA AMENDMENTS
All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Please return marked up set of drawings with corrections.(Information) The applicant shall obtain clearances/approvals for the following prior to building permit issuance:
- Planning Division approval on the corrected/final set of drawings (647-5804.) Previously approved plans
should be submitted to expedite the process.
- Police Department approval on the corrected/final set of drawings (647-5840)
- Public Works Agency approval (647-5039)PLAN CHECK COMMENTSSheet G-101.0. Revise the maximum slope of accessible pedestrian walk from 8.3% to 5%.PC2: The design does not comply as an accessible ramp. Provide fully accessible ramp design, elevations, and details with dimensions on the plan per 11B-405. A note alone on plan is not acceptable. (e.g. landings, handrails, edge protection…). Please note that there is no room for top (minimum 60”x60”) and bottom landing for the ramp (minimum 72”x60”). It is not allowed to use public sidewalk as part of the landing. It is recommend to design as an accessible route with 5% maximum running slope and 2% cross-slope. Sheet G-101.0. Show 36” minimum wide detectable warnings on plan.Sheet G-101.0. Provide and cross-reference detectable warnings detail on plan. Show compliance with CBC 11B-705.1.PC2: Incorporate Figure 11B-705.1 into plan.Sheet G-104.0. Identification with an ISA(International Symbol of Accessibility) and signs identifying van accessible spaces are required. Show compliance in detail 2/G-100.0.PC2: Detail 2/G-100. Delete wording “Reserved parking” from the sign.Sheet G-104.0. Add note to detail 4/G-100.0 that “NO PARKING” marking in the stall shall be 12” minimum in height.Provide complete (3) sets of drawings including all sheets as indicated in the sheet index. 2 of the (3) sets are not complete with missing G-sheets and S-sheets.PC2:Separate all E-sheets from the building plan check set. Assemble G-sheets and S-sheets together only in the Building plan check set.E-sheets are reviewed under electrical plan check. Do not assemble them in the building plan check set. Assemble them separately.END OF COMMENTS