HomeMy WebLinkAbout284068_1_Corrections.docxRESIDENTIAL PLAN CHECK
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
101109392
PROJECT ADDRESS:
1101 S Magnolia Ave Unit# 2
PLAN CHECK ENGINEER:
Lo, JonathanTEL:714
647-5822
EMAIL:
Jlo@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
R-3, U
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
2/9/2022
INITIAL REVIEW
2/25/2022
EXPIRATION
8/8/2022
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Benito Corona
3.
TEL:
(714)371-7176
FAX:
(914)339-8869
VALUATION: $50,000.00
EMAIL:
bcndesigner@sbcglobal.net
FLOOD ZONE: X-0602320257J
Note: Numbers in parenthesis (unless otherwise noted) refer to code sections of the 2019 California Residential Code (CRC); 2019 California Building Code (CBC); CMC = 2019 California Mechanical Code; CPC = 2019 California Plumbing Code; CEC = 2019 California Electrical Code; T = Table; ICC = International Code Council.All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit corrected sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5822 for an appointment.
The applicant shall obtain clearances/approvals for the following, prior to building permit issuance:
☒Planning Division approval on the corrected/final set of drawings (647-5804). Previously approved plans should be submitted to expedite the process.
☒Public Works Agency approval (647-5039).
☐Fire Department approval on the corrected/final set of drawings (647-5839 or 647-5700).
☒Police Department approval on the corrected/final set of drawings (647-5840).
☒School District Approval; and a copy of the school fee worksheet, completed by the plan check engineer, shall be required by the School District to verify the scope of the work.
☐Proof of Worker's Compensation Insurance shall be required at the time of permit issuance.
☐Grading Permit. Application is made through the Building Safety Division (647-5800) and the plan review is by the Public Works Agency (647-5039).Comments have been provided on drawing and calculation hard copies in relation to all comments below. These may be picked up at Building and Planning department at applicants’ discretion.DrawingsSheet A-1Provide Flood Zone: X on project data.Sheet A-2Verify window type in Bedroom 1 with elevations. Does not seem to be single hung door.Drawings are pen noted, “Water heater to be enclosed in a closet flush w/ façade or relocated to interior”. Ensure enclosure or relocation is provided prior to permit.Detail 1 – Detail is cut off at border, please fix.Sheet S-1Add note to verify in field existing foundation at existing garage door opening, else new footing required. Key Note #2 on Roof Framing Plan notes beam post cap. No post is provided in plans, please provide.Confirm all Key Note #2 on plan, note seems to be pointed at various things such as headers and ceiling joists at headers. Provide post as needed.Provide dimensions on plan for sistered ceiling joist locations.Verify detail 3B called out on roof framing plan.Provide 2x blocking sizes on plan or reference location where size can be found.Provide detail for new kickers at sistered ceiling joists.Provide dimensions on plan where 2x blocking occurs.Verify or remove “Not applicable for this project” for wind design. Wind design is still applied even if not governing case and should still be applicable.Detail 1 – Dowel new footing to existing footing.Detail 5 – Verify Note #4 is new or existing.Sheet Residential T24 Sheet 2 of 3Responsible Person’s Declaration Statement shall be filled out and signed by appropriate party.CalculationsSheet 13 of 19 – Verify if 3 separate Lines of LFRS occurs in transverse direction and where Line 3 occurs.Sheet 14 of 19 – Verify shear wall lengths used. Lengths shown on drawings do not match calculations. Revise to match or provide redesign for smaller lengths. (End of Comment)