HomeMy WebLinkAbout282341_2_Corrections.docxRESIDENTIAL PLAN CHECK
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
101108885
PROJECT ADDRESS:
2727 N Main Place Dr
PLAN CHECK ENGINEER:
Lee, WayneTEL:714
647-5848
EMAIL:
wlee@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
III A, SPK, SPK Story Increase
OCCUPANCY CLASSIFICATION(S):
A-3, B, R-2
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
12/14/2021
INITIAL REVIEW
1/11/2022
EXPIRATION
6/12/2022
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Vignesh Kamath
3.
TEL:
(702)595-8995
FAX:
VALUATION: $0.01
EMAIL:
vkamath@lowe-re.com
FLOOD ZONE: X-0602320163J
Note: Numbers in parenthesis (unless otherwise noted) refer to code sections of the 2019 California Residential Code (CRC); 2019 California Building Code (CBC); CMC = 2019 California Mechanical Code; CPC = 2019 California Plumbing Code; CEC = 2019 California Electrical Code; T = Table; ICC = International Code Council.All items noted on this plan check report must be addressed.
Please see corrections on submitted plans. Red marked set must be returned with revised plans. Plans resubmitted without the red markup set may result in delayed review time and additional plancheck fees.
All drawings and supporting documents shall be prepared, stamped, and signed by a California licensed architect or registered professional engineer. (CRC R301.1.3, CBC 107.1 and 107.3.4.1).
The applicant shall obtain clearances/approvals for the following, prior to building permit issuance:
-Planning Division approval on the corrected/final set of drawings (647-5804). Previously
approved plans should be submitted to expedite the process.
1-hour fire-barrier walls between clubroom and lobby and between business room and lobby are required. (707). Openings shall be protected and fire-rated as required. (716). For example, on sheet I-101, plan shows non-rated openings and non-rated partitions between clubroom and lobby and between business room and lobby have not complied with corridor and area separation requirements. Please coordinate with the architectural plans to update the relevant interior design and drawings.Add note to cover sheet: interior wall and ceiling finish schedule shall be in compliance with CBC Section 803 and CBC Table 803.13.Incorporate CBC 803 code requirements into the drawings. Incorporate CBC Table 803.13 into the drawings.Add note to cover sheet:Interior floor finishes shall be in compliance with CBC Section 804.Incorporate CBC section 804 code requirements into the drawings.Sheet I-002, I-003: Please justify on plan that the plastic laminated floor (PI-) in public area and corridorcomplies with CBC Section 804. In the finish schedule, show test and classification information for those finish materials. (804)
END OF COMMENTS