HomeMy WebLinkAbout283318_2_Corrections.docxRESIDENTIAL PLAN CHECK
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
101109160
PROJECT ADDRESS:
2401 3/4 S Pullman St Unit# WCC01
PLAN CHECK ENGINEER:
Lo, JonathanTEL:714
647-5822
EMAIL:
Jlo@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
B
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
1/19/2022
INITIAL REVIEW
1/24/2022
EXPIRATION
7/18/2022
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Travis Wells
3.
TEL:
(619)928-2189
FAX:
VALUATION: $25,000.00
EMAIL:
Twells@core.us.com
FLOOD ZONE: X-0602320278J
Note: Numbers in parenthesis (unless otherwise noted) refer to code sections of the 2019 California Residential Code (CRC); 2019 California Building Code (CBC); CMC = 2019 California Mechanical Code; CPC = 2019 California Plumbing Code; CEC = 2019 California Electrical Code; T = Table; ICC = International Code Council.All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit corrected sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5822 for an appointment.Comments have been provided on drawing and calculation hard copies correlating to all comments below. These may be picked up at Building and Planning department at applicants’ discretion.DrawingsSheet T-1Add sheet A-5 to sheet index.Sheet T-2Provide wind and seismic design data per CBC section 1603.Sheet A-1.1Provide anchorage calculations for (N) Unit and RackDetail 1 and 3/D-2 are referenced for new rack, verify which detail anchorage applies.CalculationsCover Page – Verify EOR for project on cover sheet, calculations and drawings are stamped and signed by different licensed engineers.Page 12 – Verify (E) footing occurs @ conc slab and specify on plans. If existing footing is surrounded by grade, revise design to unrestrained condition. This may result in fewer new antennas or providing new slab to restrain existing footing.(End of Comment)