HomeMy WebLinkAbout284103_2_Corrections.docxRESIDENTIAL PLAN CHECK
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
101109406; 07; 08; 09
PROJECT ADDRESS:
2305 S Center St Unit# C & others address (see highlighted PC #’s above)
PLAN CHECK ENGINEER:
Le, TungTEL:714
647-5896
EMAIL:
Tle10@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
R-2
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
2/10/2022
INITIAL REVIEW
3/17/2022
EXPIRATION
8/9/2022
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Mike Abbas
3.
TEL:
(818)442-4455
FAX:
VALUATION: $7,000.00
EMAIL:
souria24@yahoo.com
FLOOD ZONE: X-0602320259J
Note: Numbers in parenthesis (unless otherwise noted) refer to code sections of the 2019 California Residential Code (CRC); 2019 California Building Code (CBC); CMC = 2019 California Mechanical Code; CPC = 2019 California Plumbing Code; CEC = 2019 California Electrical Code; T = Table; ICC = International Code Council.All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 2corrected sets of plans.
The applicant shall obtain clearances/approvals for the following, prior to building permit issuance:
-Planning Division approval on the corrected/final set of drawings (647-5804). Previously
approved plans should be submitted to expedite the process.
Sheet A1: Handrail extension at the bottom landing – Please revise plan to show handrail continues at a distance of one tread plus the 12” horizontal extension.
Sheet A2: Please coordinate and revise elevation to show the revised handrail extension.
Sheet S1: Detail 8, handrail – Please show handrail edges with a minimum radius of 0.01 inch.