HomeMy WebLinkAbout288108_1_Corrections.docxTENANT IMPROVEMENT
PLAN CHECK COMMENTS
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
101110595
PROJECT ADDRESS:
1610 W Edinger Ave
PLAN CHECK ENGINEER:
So, AnsonTEL:714
647-5830
EMAIL:
Aso@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
S-1
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
5/31/2022
INITIAL REVIEW
6/12/2022
EXPIRATION
11/27/2022
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
David Chong
3.
TEL:
(213)254-5341
FAX:
VALUATION: $20,000.00
EMAIL:
david@blenddesignla.com
FLOOD ZONE: X-0602320257J
APPLICABLE CODE: 2019 CALIFORNIA BUILDING CODE (CBC) WITH
CITY OF SANTA ANA AMENDMENTS
All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 3corrected sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5830 for an appointment.Sheet A.001Revise the California Code Standards to the edition “2019” under Applicable Codes.Revise the occupancy group to “S-1” under Project Data.To avoid confusion, delete the number “1.” In front of the floor area “229”. The scope of work appears to be “1,229” square-foot addition.Include the structural sheets under the Drawing Index.Sheet A.100Provide an one-hour fire rated assembly detail for the exterior south wall and east wall. The fire separation distance are less than 10 foot at the southern and eastern location. An one hour rated walls are required.On the East Elevation drawing, specify dimension of the overhang.Sheet S1.00Specify the header size on top of the double-door location.[END]