HomeMy WebLinkAbout290457_1_Corrections.docxTENANT IMPROVEMENT
PLAN CHECK COMMENTS
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
101111326
PROJECT ADDRESS:
325 N Tustin Ave
PLAN CHECK ENGINEER:
Le, TungTEL:714
647-5896
EMAIL:
Tle10@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
II B
OCCUPANCY CLASSIFICATION(S):
M
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
7/25/2022
INITIAL REVIEW
8/4/2022
EXPIRATION
1/21/2023
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Joel Anderson
3.
TEL:
(714)850-7575
FAX:
VALUATION:
EMAIL:
janderson@bundyfinkel.com
FLOOD ZONE: X-0602320277J
APPLICABLE CODE: 2019 CALIFORNIA BUILDING CODE (CBC) WITH
CITY OF SANTA ANA AMENDMENTS
All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 2corrected sets of plans.The applicant shall obtain clearances/approvals for the following prior to building permit issuance:
- Planning Division approval on the corrected/final set of drawings (647-5804.) Previously approved plans
should be submitted to expedite the process.Detail C/DT-1 and F/DT-2: Please provide side elevation to show the concrete raised pump island not more than 10” projected from the card reader/pad and dispenser handle. (11B-309). Details C/DT-1 and F/DT-2: Please transfer details to the architectural plans. Details shall be stamped, signed and dated by the licensed architect. Plan sheets MT-1 through DT-4 are for reference only. Please note on plan. Please provide structural calculation and details for the dispensers support and anchorage. Calculation and structural plans shall be stamped, signed, and dated by a California registered civil engineer. (End of Comment)