Loading...
HomeMy WebLinkAbout289119_2_Corrections.docxTENANT IMPROVEMENT PLAN CHECK COMMENTS COMMENTS Planning & Building Agency Building Safety Division 20 Civic Center Plaza P.O. Box 1988 (M-19) Santa Ana, CA 92702 (714) 647-5800 www.santa-ana.org PLAN CHECK NO: 101110906-909 PROJECT ADDRESS: 216 W Fourth St Unit# A, B, C, D PLAN CHECK ENGINEER: Le, TungTEL:714 647-5896 EMAIL: Tle10@santa-ana.orgFAX:714 647-5897 TYPE OF CONSTRUCTION: V B OCCUPANCY CLASSIFICATION(S): B PLAN CHECK DATES: REMARKS/RECHECK ITEMS: APPLICATION 6/21/2022 INITIAL REVIEW 8/4/2022 EXPIRATION 12/18/2022 RECHECKS: 1. PROJECT APPLICANT CONTACT PERSON: 2. Gani Dino 3. TEL: (323)217-3558 FAX: VALUATION: $15,000.00 EMAIL: ganiedino@yahoo.com FLOOD ZONE: X-0602320276J APPLICABLE CODE: 2019 CALIFORNIA BUILDING CODE (CBC) WITH CITY OF SANTA ANA AMENDMENTS All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Resubmit 2corrected sets of plans.The applicant shall obtain clearances/approvals for the following prior to building permit issuance: - Planning Division approval on the corrected/final set of drawings (647-5804.) Previously approved plans should be submitted to expedite the process. - Police Department approval on the corrected/final set of drawings (647-5840) - Public Works Agency approval (647-5039) - County of Orange Health Department approval on the corrected/final set of drawings ((714)433-6000) - School District Compliance Certificate; a copy of the building permit application, signed by the plan check engineer, shall be required by the School Districtto verify the scope of work. Refer to the attached handout.Sheet T-1: Job address: Please revise plan to include all the addresses on the plan, including suite numbers. Apply to all plan sheets. On the, please provide/show floor area for all levels, including first floor and basement. And, specify the use of space and occupancy group(s) for each level. Please provide an architectural Site Plan (Plot Plan) with property lines, streets, north arrow, etc. Google map / aerial map is not acceptable. Plan must be legible and drawn to scale. Please provide occupant calculation for each area of reach floor. This is an existing unreinforced masonry building with limited total occupant load of 99 occupant maximum. On the plan, please show location of accessible parking serving the building. Scope of work: Please clearly specify what level the works are proposed. On the plan, please provide an accessible route Sheet D-1: Please provide existing floor plans for first and basement level. Sheet A-1: Please transfer the handwritten address to the electronic file prior to printing. For clarity, please show/provide office layout for each unit, including partitions and furniture. Corridor: On the plan, please specify one-hour fire-rated corridor and one-hour rated stairway enclosure. Verify and provide details to show one-hour wall assembly for the existing walls. Details shall be clearly cross-referenced onto the plan. One-hour walls: For clarity, please change wall type (line) to differentiate between fire-rated corridor wall and interior partition wall. Existing door to the stairway adjacent to the roof deck: Door shall be made accessible to person with disability. Please revise plan to show door swing into the corridor and provide 5-ft landing on the corridor. Existing roof deck: Please specify “Unoccupied roof deck”. Please provide first floor to show means of egress and exit discharge. Detail 4/A-3: Wall separating units shall be extended to the underside of the roof sheathing. Detail 1/A-3: Fire-rated wall shall be terminated at the underside of roof sheathing. Please revise detail accordingly. Detail 7/A-3: Fire-rated wall shall be terminated at the underside of roof sheathing. Please revise detail accordingly. Steel stud: On the plan, please specify ICC report number for the steel studs. **Plan was incomplete. Plan review will continue and additional comments will be required. (End of Comment)