HomeMy WebLinkAbout303858_2_Corrections.docxSPC
PLAN CHECK COMMENTS
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
101115611
PROJECT ADDRESS:
101 S Harbor Blvd
PLAN CHECK ENGINEER:
Huang, GaryTEL:714
647-5862
EMAIL:
Ghuang@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
B
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
6/27/2023
INITIAL REVIEW
7/2/2023
EXPIRATION
12/24/2023
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Kasey Clark
3.
TEL:
(951)471-8419
FAX:
VALUATION:$12,400.00
EMAIL:
info@akcservices.net
FLOOD ZONE:X-0602320256J
GUIDELINES:
Comments contained within this report reflect only those of the Building and Safety Division. Additional comments or corrective action may be required by other Departments and/or outside Agencies
This Plan Review Report and all subsequent code references are based upon the most recent version(s) of the 2022 California Building Codes (CBC, CRC, CFC, CEC, CPC, CMC, CGBSC, and CEES)
The approval of plans and any supporting documents does not permit the violation of any section of the adopted building codes or other pertinent local ordinances, or state and federal laws
All listed plan review comments must be adequately addressed before a building permit can be issued
Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.
PLAN REVIEW COMMENTS:
Applicant shall address all the checked‘☒’ correction comments below before resubmitting plans to Building Safety for recheck.
☒1. The applicant shall obtain clearances/approvals for the following, prior to building permit issuance:
☒Planning Division approval on the corrected/final set of drawings (647-5804). Previously approved plans should be submitted to expedite the process.
☐Fire Department approval on the corrected/final set of drawings (647-5839 or 647-5700).
☐Police Department approval on the corrected/final set of drawings (647-5840).
☐Public Works Agency approval (647-5039).
☐Proof of Worker's Compensation Insurance shall be required at the time of permit issuance.
☐School District Approval; and a copy of the school fee worksheet, completed by the plan check engineer, shall be required by the School District to verify the scope of the work.
☐Grading Permit. Application is made through the Building Safety Division (647-5800) and the plan review is by the Public Works Agency (647-5039).
Sheet DEV-COAS-00667-r7 (9 of 15):
EOR to provide engineering stamp & signature on this sheet
Top view: provide welding requirement at framing corner
Section view: provide fastener schedule. EOR to verify/clarify that only one 3/8” lag bolt along the height of the unit? Provide additional connection as required
Sheet DEV-COAS-00667-r7 (10 of 15)
EOR to provide engineering stamp & signature on this sheet
Framing section view: ENGR to provide connection of 4x4 plate to HSS 1 ½”x1 ½” tube
Section view: provide welding of 4x4x1/8 aluminum angle welding to framing.
Sheet COAS-CNPY-00011 (1 of 2)
EOR to provide engineering stamp & signature on this sheet
Sheet COAS-CNPY-00011 (2 of2)
EOR to provide engineering stamp & signature on this sheet
EOR to provide connection detail at each framing intersection typical.
Red marked comment set is available to pick-up at the City Hall.(End of Comment)