HomeMy WebLinkAbout312822_1_Corrections.docxRESIDENTIAL PLAN CHECK
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
101118341
PROJECT ADDRESS:
1423 N Mar-Les Dr
PLAN CHECK ENGINEER:
Ahangian, KathyTEL:714
647-5812
EMAIL:
Kahangian@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
V B, SPK
OCCUPANCY CLASSIFICATION(S):
R-3, U
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
2/26/2024
INITIAL REVIEW
3/7/2024
EXPIRATION
8/24/2024
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Xavier Velasco
3.
TEL:
(714)745-4407
FAX:
VALUATION:
EMAIL:
xavierjordi@posteo.net
FLOOD ZONE: X-0602320143J
Note: Numbers in parenthesis (unless otherwise noted) refer to code sections of the 2022 California Residential Code (CRC); 2022 California Building Code (CBC); CMC = 2022 California Mechanical Code; CPC = 2022 California Plumbing Code; CEC = 2022 California Electrical Code; T = Table; ICC = International Code Council.All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used. Please pick up the red marks from permit counter.Resubmit 2corrected sets of plans.Meetings between the project applicant/designer and the plan reviewer shall be by appointment only. Please call (714) 647-5812 for an appointment.
Please see corrections on submitted plans. Red marked set must be returned with revised plans. Plans resubmitted without the red markup set may result in delayed review time and additional plancheck fees.
All drawings and supporting documents shall be prepared, stamped, and signed by a California licensed architect or registered professional engineer. (CRC R301.1.3, CBC 107.1 and 107.3.4.1).
Provide calculation to justify header/beam # 5 and 4x10 header at the closet can carry loads from Girder trusses. ( provide loading)
Provide post at end of each Girder truss.
Show location of all required posts for trusses on the floor framing plan.
Provide beam to support jack trusses at the stairways.
It is not clear, is girder truss stops at the bathroom or it spans all the way to the wall. Roof framing doesn’t match the truss plan. ( please see red mark)
On truss calcs , provide complete reaction for the girder trusses to match engineering calculation.