HomeMy WebLinkAbout330838_2_Corrections.docxSPC
PLAN CHECK COMMENTS
COMMENTS
Planning & Building Agency
Building Safety Division
20 Civic Center Plaza
P.O. Box 1988 (M-19)
Santa Ana, CA 92702
(714) 647-5800
www.santa-ana.org
PLAN CHECK NO:
101124176
PROJECT ADDRESS:
3301 S Harbor Blvd Unit# 113
PLAN CHECK ENGINEER:
Lee, WayneTEL:714
647-5848
EMAIL:
wlee@santa-ana.orgFAX:714
647-5897
TYPE OF CONSTRUCTION:
V B
OCCUPANCY CLASSIFICATION(S):
B, S-1
PLAN CHECK DATES:
REMARKS/RECHECK ITEMS:
APPLICATION
7/1/2025
INITIAL REVIEW
7/22/2025
EXPIRATION
12/28/2025
RECHECKS:
1.
PROJECT APPLICANT CONTACT PERSON:
2.
Colin Price
3.
TEL:
(714)717-7490
FAX:
VALUATION:$6,500.00
EMAIL:
argonaut@abcglobal.net
FLOOD ZONE:X-06059C0258J
APPLICABLE CODE: 2022 CALIFORNIA BUILDING CODE (CBC) WITH
CITY OF SANTA ANA AMENDMENTS
All items noted on this plan check report must be addressed. If you feel that an item is not applicable to your project, note “N/A” and discuss the reason with the plan checker.Please indicate the sheet number and detail to the right of each correction, or note the number on the plans where the correction is made. Resubmit marked original, calculations and this correction sheet. A separate sheet for response may be used.Please refer to red marks on the drawings for additional plan check comments. Revise drawings to show compliance.The applicant shall obtain clearances/approvals for the following prior to building permit issuance:
- Planning Division approval on the corrected/final set of drawings (647-5804). Previously approved plans
should be submitted to expedite the process.
- Fire Department approval on the corrected/final sets of drawings ((714) 573-6100).PLAN CHECK COMMENTSSheet T-1. Clarify the scope of work to match permit application: “Add (10) 10 feet high storage racks”.Sheet T-1. Revise sheet index to show revised structural sheet number. Please consult structural engineer for new sheet number. (25-1737-A are duplicated on two sheets.)Sheet A-1. Refer to redlines on plan to provide dimensions to show clearance between racks and the clearance must not less than 44 inches between racks. (11B-404)Last sheet 25-1737-A. Refer to side view on rack type A01 and A02 elevation. Revise 42” wide racks to design 48” wide to match architectural section. See architectural sheet A-1 detail 2.Last sheet 25-1737-A. Please assign new sheet number. There are duplicated25-1737-A sheet number on two sheets.END OF COMMNETS