80A - JOINT WORK CENTER MOU - Laserfiche WebLink

Home Browse Search

EXHIBIT 3 EXHIBIT B — OUTLINE SPECIFICATIONS DIVISION 2 D. Carpet tile requirements: 1. Density: 5000 minimum; heavy commercial use. 2. Tuft bind strength shall be minimum 5 lbs., ASTM D 1335-98: Standard Test Method for Tuft Bind (edge ravel) of Pile Yarn Floor Coverings, tested wet or dry. Warranty edge ravel for 10 years. a) Face yarn weight: Minimum 16 oz./sq. yd. b) Minimum of 10 lbs, backing delamination test, per ASTM D 3936-05 Standard Test Method for Resistance to Delamination of the Secondary Backing of Pile Yarn Floor Covering. c) Minimum rating of 7 anti -stain tests, per AATCC Test Method 175-2008 Stain Resistance Pile Floor Coverings. d) Lessor shall provide 2 percent of product overage, including accent carpet, up to a maximum of 100 sq. yards from the same dye lot for future repairs. E. Ceramic the flooring requirements: 1. Ceramic tile flooring shall have a coefficient of friction of at least 0.6 per ASTM C 1028 (0.8 percent on sloped surfaces steeper than 6 percent). Unless otherwise noted by DGS, provide slip -resistant floor tile with matching wall tile base, and include all inner and outer corner and trim pieces. All adhesives, mastics, and grouts shall be non -toxic and low in volatile organic compound (VOC) emissions and shall be as recommended by the ceramic tile manufacturer. All grout shall be sealed and maintained according to manufacturer's guidelines. F. Resilient flooring requirements: 1. Resilient flooring shall meet ASTM F 1066, FS SS-T-312B, Type IV, Composition 1, Class 2, 12" x 12" having uniform thickness of 1/8" with square true edges of manufacturer's standard color and pattern as selected. Product shall comply with all regulations controlling the use of VOCs. Provide one carton (40 pieces) of additional matching floor tile. 2. Resilient flooring shall have a coefficient of friction of at least 0.6 per ASTM D 2047. it shall be installed in strict accordance with manufacturer's approved installation instructions using the appropriate recommended 100 percent solvent - free adhesive. G. Rubber base requirements: 1. Lessor shall provide and install cove wall base at all carpet and resilient floor finish areas. Wall base shall be extruded rubber cove, 1/8" thick x 4" high complying with ASTM F-1861. The color shall be selected by DGS. 2.2 EXTERIOR WALLS A. Exterior walls, including door and window assemblies, shall be weatherproof. All cracks that allow outside air to penetrate the building's envelope shall be sealed. B. Exterior walls shall be insulated to comply with CCR Title 24. 2.3 INTERIOR WALLS, PARTITIONS AND VESTIBULES A. Walls and partitions shall be ceiling height unless otherwise noted in Exhibit "A" or Division 3'Special Provisions.' Subject to code limitations, those indicated as new partitions may be wood or metal stud with plaster or gypsum wallboard or other construction of equal sound transmission coefficient (STC). Provide a minimum STC 32. 16 Rev. March 2010 80A-626