80A - JOINT WORK CENTER MOU - Laserfiche WebLink

Home Browse Search

EXHIBIT 3 EXHIBIT B — OUTLINE SPECIFICATIONS DIVISION 2 B. Exterior signs (applicable only if building is totally occupied by the State): Lessor shall provide and install exterior signs. Letters shall be of cast aluminum alloy, bronze, black anodized finish or dimensional plastic. Submit samples to DGS for approval. The words "STATE OF CALIFORNIA" and the name of the occupying department, and street address shall be in scale with the building elevation. a) Lessor shall be solely responsible for any additional permits and fees. F. Assistive listening devices: 1. Lessor shall provide an assistive listening device system for all meeting, conference, quiet, assembly, and gathering rooms. The system shall comply with all accessibility requirements. Occupant load less than 50: a) One portable system per floor can be shared between rooms with occupant loads less than 50. The system shall be designed to accommodate the largest room size that is being shared. The portable, wireless FM -based system shall include high output acoustic headset(s) such as the Centrum Motive PFM 360 (or current model) with disposable ear plugs, neck-loop(s), conference microphones and a lockable chargerlaccessory carry case large enough to hold all equipment. The system shall be hearing aid compatible. Lessor shall provide signage at reception area indicating that the device is available. Occupant load of 50 or more: b) Rooms with more than a 50-person occupant load and fixed seating must have a fixed assistive listing device system for 4 percent of the total number of seats in these rooms, but not less than two seats. Lessor shall provide signage inside each room and in the common hallway and/or corridor indicating that the device is available. G. Modular systems furniture (MSF): 1. The State may elect to furnish and install MSF in lieu of traditional office furniture. MSF may be comprised of any combination of freestanding partition panels, panel - supported work surfaces, files, components, and access raceways. Where the State elects to install MSF as described above, Lessor, at Lessor's sole cost and expense, shall perform the following: c) Obtain any required permits from the local jurisdiction. d) Provide electrical engineering and installation of all wiring systems and components as necessary or required from the building's electrical system to the MSF for a complete and fully operational system, e) Provide a minimum of four 20-amp circuits to each base feed and/or power pole feed. Each base feed or power pole shall serve a maximum of four workstations. f) Coordinate electrical junction box locations with State -furnished MSF plans. See Division 3 Special Provisions for MSF wiring diagram. g) Install voice and data communication cabling from the data communication closet to the final point of termination at the MSF panel. h) Cut and assemble the supplied power pole to the appropriate length, insert pole into top trim of panel, align the pole true and plumb, seismically brace pole, cutting the correct size hole in the ceiling tile, routing the electrical and data conduit 22 Rev. March 2019 80A-632