MAJOR LEAGUE INFIELDS, INC. (2) - Laserfiche WebLink

Home Browse Search

12.5.1 After raking/shoveling loose material from high spots back into low spots/worn areas on running paths, sliding zones, and any other low spots/worn areas appearing on the field, the Contractor shall fill all remaining low spots with new Stabilizer Solutions Stabilizer Gold Infield Mix (with stabilizer). brickdust fiom stock and make level. 12.5.2 The contractor shall clean all excess brickdust beneath or next to the backstop; dugout chain link fencing and/or infield chain link fence lines so that the infield brickdust is level with the dugout pavement and pavement outside the infield. 12.5.3 Lightly water entire infield before dragging. Note: Watering shall penetrate brickdust to a minimum depth of 1/8" deep min. This process is crucial to keeping brickdust in place and not going air home. 12.5.4 Drag infield utilizing small utility vehicle as specified with "grooming or finishing drag". Circular or figure eight drag patterns shall be used (see details I -A & 1-13). Alternate drag patterns or reverse direction of drag patterns daily to avoid ruts and high/low areas. Speed of drag procedure shall not exceed 7 mph. 12.5.5 When dragging the skinned infield, the contractor shall stay away from all turf edges a minimum of 18". This will help in avoiding lips at brickdust/turf edges. This 18' gap shall also apply to all backstops and chain link fence areas. 12.5.E Contractor shall hand rake all base paths on combination turf/brickdust infields. 12.5.7 When the dragging process is complete, the contractor shall stop the drag in a different location daily. This will stop the accumulation of brickdust in focused areas. At this time roll -up the drag, place it on the vehicle and remove all debris accumulated in the drag at this spot and rake out material emptied from drag. 12.5.8 After dragging, hand rake the 18" edges using the "grade or grooming rake". The rake shall be held at an angle as to not push brickdust onto/into turf areas. 12.5.9 After raking the 36" edges, the contractor shall clean all excess brickdust on the turf edges utilizing a high pressure water nozzle or heavy duty broom. NO brickdust shall be permitted on the turf edges at any time. If in the determination of City staff, an unsafe lip situation exists (an unsafe lip is V2" or greater) in any turf/brickdust border area infield to brickdust, base -paths or brickdust to outfield), contractor will be required to remove or level the soil build-up with a sod cutter and re-establish the in -field boundaries with a string line or suitable method and re -sod up to the border to remedy the situation at contractors expense. Pre-existing conditions shall be corrected during contract start-up. 12.6 Final Watering 12.6.1 This is the most time consuming and a very important element of the procedure. 12.6.2 The contractor shall final water the skinned brickdust to a depth of A" minimum t3.0 Rainy Weather/Wet Field Procedure 13.1 On the next scheduled working day after a rainfall, the following procedure, in the order listed, shall be adhered to: 13.1.1 Remove all standing water from low spots either by skimming off excess water and spreading it out to dry areas or using a pump/copper system. 13.1.2 Rake out (scarify) wet areas. 13.1.3 Apply Stabilizer Solutions Stabilizer Gold Infield Mix (with stabilizer) from stock to all Wet Areas and Rake Out. Cap with calcified clay Turface. City of Santa Ana RFP 19-093 Page 18