ABM BUILDING SOLUTIONS, LLC (2) - Laserfiche WebLink

Home Browse Search

may be required to provide routine operating inspection(s) to check system performance in accordance with a program of standard routines as determined by our experience, the equipment manufacturer's published recommendations, equipment application, and location. This service will focus on equipment operation, fluid levels, operating and safety controls, and safe equipment operation. Operating Inspection,— Heating as Required The proposer may be required to provide this service to assure mechanical equipment continues to operate efficiently, safely and with minimal operating disruptions during the operating season. The City Representative will provide routine operating inspection(s) to check system performance In accordance with a program of standard routines as determined by our experience, the equipment manufacturer's published recommendations, equipment application, and location. This servicewill focus on equipment operation, fluid levels, operating and safety controls, and safe equipment operation. Operating Inspection —Cooling as Required This service may be required to assure mechanical equipment continues to operate efficiently, safely and with have minimal operating disruptions during the operating season. Proposerwill provide routine operating Inspection(s) to check system performance in accordance with a program of standard routines as recommended by the equipment manufacturer's published recommendations, equipment application, and location. This servicewill focus on equipment operation, fluid levels, operating and safety controls, and safe equipment operation. Equipment Tasking as Required The following tasks may be requested on an as needed basis. These tasks are designed to maintain the equipment in an optimum operating condition so that the equipment will operate reliably and efficiently. Reciprocating Compressors: 1. Perform annual Spectro-Chemical oil analysis test. 2. Preventive maintenance shall be performed as required. 3. Lock -out and Tag -out equipment as required. 4. Check all electrical wiring and connections and tighten as required. 5. Check starter contactor surfaces for wear as required. 6. Visually leak check compressor and associated refrigerant piping as required. 7. Clean exterior of compressor as required. B. Check operation of crankcase heater as required. 9. Meg -ohm motor from starter and record as required. 10, Check and calibrate all safety and cut-out devices as required. 11. Check and adjust compressor capacity controls as required. 12. Check, calibrate and adjust all operational controls as required. Exhaust Fans: 1. Preventative Maintenance as required. 2. Lock -out and Tag -out equipment as required. 3. Check all electrical wiring and connections and tighten as required. 4. Check all motor starter contactor surfaces for wear as required. 5. Clean starter and electrical control enclosures as required. 6. Lubricate motor bearings and fan bearings as required.