Laserfiche WebLink
Attachment A - Joint Agreement for 800 MHz CCCS Page 68 of 83 <br />• Installed in a Mobile Communications Unit/Vehicle. <br />• Installed at an Incident Communications Center or Command Post. <br />Protocol/Standard <br />Radio control stations are permissible in the following circumstances: <br />• Connected to a radio console to be used to access the System by non -System user <br />agencies for Interoperability purposes. <br />• Installed in a MCU/MCV. <br />• Installed temporarily in an Incident Communications Center or Command Post. <br />• Connected to a radio console to be used to access the System by user agencies for <br />interoperability purposes. <br />• Used with an audio logger to record transmitted or received audio. <br />All communications personnel performing the dispatch function shall be trained on the usage <br />and constraints of the control station. They should receive continued training to maintain <br />proficiency and understanding of the procedures. <br />A radio technician, COMT or other authorized person shall be involved in the configuration, <br />installation and testing of control stations, whether a temporary or permanent installation. <br />Limitations <br />• Control stations should not be used to patch a System talkgroup to another System <br />talkgroup except when approved by the Communications Center Supervisor and the <br />Control One Supervisor. <br />• Control station antennas must not exceed 20' In height. If an antenna requires more <br />height than 20' to access the System or mutual aid repeater, then a FCC license is <br />required. <br />• No control station antenna may exceed 200' In height. <br />• Control stations should use Yagi (directional) antennas when possible. <br />• Antennas should use the lowest gain possible. <br />• Control station power should be kept as low as possible. <br />Procedure <br />Any agency wanting to use one or more control stations at the same location is only permitted <br />to use that configuration if the design is compliant with this SOP. The process for obtaining <br />permission is to submit a written request for control station usage to the Lead Agency Director. <br />• The request shall describe the location, desired talkgroups/channels, antenna height, <br />power, antenna type, antenna gain and feed line type of each control station. <br />• The Lead Agency may approve, deny or request modifications to the request. <br />Management <br />The Lead Agency will manage this policy. <br />