|
Paver's e Repair, Coping, Re -plaster, Acid Washe(
<br />• Lights and Electrical (Pool/Spa and Fountain Lights, Intermatic, Compool,
<br />Remote Control, Pentair Timer/Control Systems)
<br />• Salt Systems (Auto -Pilot, Eco-Matic, Goldline, Pentair, Zodiac)
<br />• Chemical Delivery Services (Bulk supplies, delivery services)
<br />o Pool Staffing Solutions (Gate Guards, Pool Monitors, Covid Staff, Pool
<br />Lifeguards),
<br />I , Skim surface of water of pool/spa to remove all debris, leaves, dirt,
<br />b
<br />etc_
<br />2. Brush all pool/spa the to remove excess dirt, scum, and scale deposits
<br />(as needed),
<br />b
<br />3. Vacuum the bottom of the pool/spa or any related facilities to remove
<br />any debris, leaves and dirt.
<br />b
<br />4. All equipment will be maintained in safe, clean and good operational
<br />condition, Repairs will be identi6edand estimates sent for approval prior
<br />b
<br />to the repairs performed.
<br />5. Remove and clean strainer baskets around pool/spa &pump room.
<br />b
<br />6. Brush submerged surfaces (such as walls and pool steps & ladders)
<br />7 Maintain proper records in accordance with, the state, local County City or
<br />other prevailing Health Department regulations as to operation, chlorine level
<br />PH level. Records to include service performed and chemicals used,
<br />said records are to be legible and are to be kept on premises in a protected
<br />location. The
<br />contractor will maintain a journal of p6611 testing that will
<br />itemize each pool tested and in which the time, date & result will be
<br />recorded. the journal will list the normal values for the type of tester that is
<br />being used,
<br />B. The pumps, filters, disinfectant and chemial feeders, flown indicators,
<br />gauge meters and all related parts of the pool water filtration & purification
<br />be
<br />system shall kept in operational condition whenever the pool is available
<br />for use.
<br />9, Maintain all deck equipment and pool equipment in safe, clean and good,
<br />operating condition. Repairs to equipment must be approved in advance, and
<br />such repairs will be an additional:cost,
<br />10. Perform water tests and maintain the following chemical parameters for the
<br />pool being maintained, Test and record during each regular service for;
<br />pH balance, Free chlorine, Total chlorine, Cyanuric Acid, Total Alkalinity
<br />and calcium hardness,
<br />Pool Chemical Parameters
<br />pHleve reading shall be in between 7.2- 8.0
<br />Free chlorine residual, must be maintained to at least 3.00 ppm
<br />(1.5 ppm of cyanuricacid is used as stabilizer)
<br />LotalChlofirr Sarne as free chlorine reading
<br />CyanudcAdd_. reading shall not exceed 100 ppm
<br />80-110 ppm
<br />Calcium Hordne 200-600 Ppm,
<br />note., recommends that all bodies of water be equipped with automation control
<br />units, These units monitor and maintain chemicals (chlorine,pH) at perfect levels
<br />with the use of sensors, and chemical feed pumps. This assures againstany chernica
<br />damage to the plaster or equipment. Without these control units, chemical levels
<br />can not be guaranteed due to the various factors that cause chemical fluctuation,
<br />11. Maintain correct water levels to assure effective skimming and prevent
<br />cavitation
<br />
|