Laserfiche WebLink
Exhibit A <br />When establishing that areas are eligible, careful inspection with accurate, and precise <br />measurements, as described in Section V, are always required. For Spray to Drip, during the pre - <br />inspection the total project area square footage is measured. Any non -eligible square footage is <br />deducted, such as areas that already have drip irrigation or are hand watered by the customer. <br />Once the pre -inspection is complete, inspector will complete the Pre -inspection section in <br />Droplet, in full, and upload all photos and documentation. Once the Pre -inspection form has <br />been submitted, it will be reviewed by MWDOC. The square footage listed on the application is <br />to be used as a reference. The initial project area is to be based on the square footage as <br />measured during the pre -inspection. Once the initial project area square footage has been <br />determined, that number is used to reserve funding, and aLetter to Proceed (LTP) is generated <br />and sent to the customer. <br />If the applicant is applying for the Turf Removal Program simultaneously, a mandatory inspection <br />will occur for the Spray to Drip application at the time of Turf Removal pre -Inspection. <br />On -Site Pre -Inspection <br />In -person pre -inspections must include: <br />• Visual verification of existing spray irrigation <br />• Physical/manual measurement of proposed irrigation conversion area. <br />• Photos taken by inspector of project area (4 to 6), which must reflect the spray <br />irrigation at the time of inspection. Photos must be taken at appropriate angles, <br />with visible points of reference, and at a sufficient distance to allow for review. <br />Measuring Sites Aerially <br />Measuring sites aerially must include: <br />• GIS or equivalent aerial measurement <br />• Please note that measuring sites aerially is allowed for pre -inspections only. <br />• Consumer is to provide photos of the spray to drip conversion area before starting the <br />project (pre -project installation). <br />• The inspector should be capable of spotting abnormalities in pre -project photos submitted <br />by customers, and if found, should perform mandatory on -site inspections. <br />• If aerial review is not possible due to obstructions (tree coverage), or inconclusive, member <br />agency should perform a physical pre -inspection as described above. <br />Photo -based Pre -inspection <br />MWDOC can perform a photo -based pre -inspection for Sprayto Drip applicants who have already <br />received a pre -inspection for an accompanying Turf Removal application, as long as the requested <br />square footage is the same. This occurs on case -by -case scenario. <br />If the application has satisfied all of the above requirements, a Letter to Proceed is generated by <br />MWDOC and emailed to the applicant. The funding is reserved at this point and cannot increase. <br />However, the funding amount may decrease if the applicant installs less drip equipment than was <br />specified on the application or if the costs of the equipment are less than anticipated. Should the <br />