QUALITY FENCE CO. INC. - Laserfiche WebLink

Home Browse Search

CITY OF SANTA ANA fit with corner joints coped or mitered and in true alignment. Built-up parts shall be free of warp. Exposed ends and edges of metal shall be slightly rounded. Fastenings shall be concealed whenever possible. Post Spacing Requirements: Span ' Nominal (71-3/8" Rail) ' Nominal (91-1/4" Rail) Post Size -1/2" " 1 2-1/2" " 2-1/2" " 2-1/2" " Bracket Type Standard (BB301) ngle (BB304) Standard (BB301) ngle (BB304) Post Settings t'/2 O.C. 5" 5-1/2" 76-1/2" 7" 4-1/2" 5" 6" 6-1/2" Gate posts shall be set in accordance with the spacing shown in the submitted fencing design plans. Six (6) inch or four (4) inch chrome wheels shall be bolted to the gate (between the wheel plates welded near the ends of the gate bottom rail). The gate shall be set upright with the V-grooved wheels positioned over the pre- installed steel V-track inset and flushed to a concrete base that traverses the gate opening. Roller guides shall be affixed to the gate posts at a height even with the gate top rail to hold the gate in a vertical position. Gate stops shall be welded to the end of the gate or track so gate cannot pass rollers in either direction. Upon request, a fabricated manual lock shall be installed on the face of the gate. The fabricated lock's placement should not interfere with the closing of the gate. A W i-Fi capable entry keypad and buried loop detectors to be provided for gate entry upon request. A Knox Box or approved equal fire access box shall be installed alongside the keypad entry. VINYL -COATED CHAIN -LINK FENCING INSTALLATION STANDARDS: Vinyl -coated chain -link fencing and gate materials shall be furnished and installed by Contractor at locations as specified by the City on an as -needed basis. The following installation standards shall be followed: 1. Manufacturers installation and warranty requirements 2. Applicable OSHA and Cal OSHA regulations 3. Applicable building and fire code requirements 4. City Codes Refer variances between above documents and Contract Documents to Owner's Representative. Install fencing and gates according to Manufacturer's installation and warranty requirements. Contractor shall contact dig alert before installation. Install vinyl -coated chain -link fencing and gate materials to tolerances recommended by Manufacturer and per submitted and approved chain -link fencing design. Unless otherwise shown, install fencing true, plumb, and level using precision gauges and levels. Footings shall be specified by the Contractor in vinyl - coated chain -link fencing design submittal and approved by the City prior to installation. Clean surfaces of metalwork to contact concrete, removing all rust, dirt, grease and other foreign substances before concrete is placed. Secure all embedded metalwork accurately in position when concrete is placed to prevent displacement or ON -CALL INSTALLATION, MAINTENANCE AND REPAIR FOR FENCING AND GATES 26