Item 18 - Agreement With Southern California Edison Company

Home Browse Search

SCE Doc. 319004 Att. Contract No. 9.5074 Initial (_______)(_____/______/______) Licensor/Licensee -6- Rev8 2016-05-11 GS-JC personal property during the effectiveness of this Agreement, or upon termination or expiration. Licensor further assumes no duty or obligation to maintain or secure Licensee’s personal property at any time. (ii) Unless as specifically provided for in an Addendum to this Agreement, Licensee shall not store on the Property, for a period longer than twenty-four (24) consecutive hours, any personal property owned by a non-party to this Agreement. Licensee will defend and indemnify Licensor, its directors, officers, agents, subcontractors, and employees, and its successors and assigns, from any and all claims, loss, damage, actions, causes of action, expenses and/or liability arising from the storage of, damage to, and/or loss of use of such non- party’s personal property. 8. Height Limitations and Vertical Clearances: Any equipment used by Licensee or its agents, employees or contractors, on and/or adjacent to the Property, will be used and operated so as to maintain minimum clearances from all overhead electrical conductors as designated in the table below: Vehicle/ Equipment Vertical Clearance 500 kV 35 feet 220 kV – 66kV 30 feet <66kV (Distribution facilities) 25 feet Telecom 18 feet All trees and plants on the Property will be maintained by Licensee at a maximum height of fifteen (15) feet. If requested by Licensor, Licensee will remove, at Licensee’s expense, any tree and/or other planting. 9. Access and Horizontal Clearances: Licensee will provide Licensor with adequate access to all of Licensor's facilities on the Property and at no time will there be any interference with the free movement of Licensor's equipment, personnel, and materials over the Property. Licensor may require Licensee to provide and maintain access roads within the Property, at a minimum usable width of sixteen (16) feet, with commercial driveway aprons and curb depressions capable of supporting a gross load of forty (40) tons on a three-axle vehicle. The minimum width of all roads shall be increased on curves by a distance equal to 400/inside radius of curvature. All curves shall have a radius of not less than 50 feet measured at the inside edge of the usable road surface. Unless otherwise specified in writing by Licensor, Licensee will make no use of the area directly underneath Licensor's towers and will maintain the following minimum clearances: a. A 50-foot-radius around suspension tower legs, H-Frames and poles and 100-foot radius around dead-end tower legs, H-Frames and poles. b. A 25-foot-radius around all other poles. NOTE: Additional clearance may be required by Licensor for structures. 10. Parking: Licensee will not park, store, repair or refuel any motor vehicles or allow parking, storage, repairing or refueling of any motor vehicles on the Property unless specifically approved in a writing executed by Licensor.