Laserfiche WebLink
ORDINANCE NO. NS-1424 <br />Page 18 <br /> <br />e <br /> <br />Examine the assembly and determine a <br />method and position for inserting a tool <br />through the assembly from the outside so <br />as to contact the primary locking device <br />or the latch. Two different tools shall <br />be used: a knife or spatula with a thin <br />blade approximately 1/32 inch thick, not <br />more than one (1) inch wide and no longer <br />than six (6) inches; and a piece of stiff <br />steel wire with a diameter of approxi- <br />mately 1/16 inch. Determine whether it is <br />possible to insert the wire or manipulate <br />with either of these tools so as to unlock <br />the door within a five (5) minute time <br />period. <br /> <br />m. with the following tools: <br /> <br />(1) <br /> <br />A knife or spatula with a thin blade <br />approximately 1/32 inch thick, not <br />more than one (1) inch wide, and no <br />longer than six (6) inches; and <br /> <br />(2) A straight or Phillips screwdriver <br /> with a maximum six (6) inch shaft <br /> <br />Remove from the door assembly all screws, <br />glazing beads, or other mechanical fas- <br />teners which can be removed readily from <br />the exterior within a time limit of five <br />(5) minutes. Determine if the primary <br />locking device can be unlocked or entry <br />gained by manipulation as described in <br />Test 1, infra. <br /> <br />Fixed Panels. Fixed panels shall be fastened <br />in accordance with the manufacturer's in- <br />structions. Tests shall be performed in the <br />following order: <br /> <br />a® <br /> <br />with the panels in the normal position, a <br />concentrated load of 300 pounds shall be <br />applied at midspan of the fixed jambstile <br />in the direction parallel to the plane of <br />the glass that would tend to remove the <br />fixed panel from the frame jamb pocket. <br />With the load applied, determine if entry <br />can be gained by manipulation as described <br />in Subsection B, 3, 1, infra. <br /> <br />b® <br /> <br />With the panels in the normal position, a <br />concentrated load of 300 pounds shall be <br />applied at midspan of the fixed jambstile <br />in the direction parallel to the plane of <br />the glass that would tend to remove the <br />fixed panel from the frame jamb pocket <br />while, simultaneously, an additional <br />concentrated load of 150 pounds is applied <br />at midspan of the fixed panel interlock <br />stile in the direction perpendicular to <br />the plane of the glass which would tend to <br />disengage the meeting stiles. With this <br />load applied, determine if entry can be <br />gained by manipulation as described in <br />Subsection B, 3, 1, infra. <br /> <br /> <br />