Laserfiche WebLink
ORDINANCE NS-2171 355 <br />Page 10 <br /> <br />and sealed and shall be equipped with safety covers <br />approved by the health officer. The minimum clearance <br />from the floor to the light fixture shall be at least 188 <br />cm (76 inches) or the fixture shall be installed out of <br />the traffic aisle or work area. <br /> <br />(f) High voltage (110-120 v) electrical wiring shall be <br /> properly installed in electrical conduit with all splices <br /> or connections being made within junction, outlet, or <br /> switch as to prevent the use of extension cords exceeding <br /> 183 cm (6 feet). Outside electrical connection <br /> receptacles shall be of weatherproof design with cover. <br /> <br />(g) Attached, firmly anchored seats with backrests, equipped <br /> with seat belts, shall be provided for all occupants. If <br /> a jump scat in the aisleway is utilized, it shall fold in <br /> a manner that will clear the aisleway when not in use and <br /> be held with a self-latching mechanism. Seats and <br /> backrests shall be at least 35.5 cm X 35.5 cm (14 inches <br /> X 14 inches) in size. All occupants shall be seated, <br /> shall wear seat belts and shall not cook or prepare food <br /> while the vehicle is in motion. Signs setting forth the <br /> latter three (3) requirements shall be posted in both <br /> English and Spanish. <br /> <br />(h) A first aid kit approved by the health officer shall be <br /> provided and located in a convenient area in an enclosed <br /> case. <br /> <br />(i) <br /> <br />Ail pressure cylinders shall be securely fastened to a <br />rigid structure of the unit. All liquefied petroleum gas <br />(LPG) equipment shall be installed as follows: <br /> <br />(1) The LP-gas tanks and relief valves shall be <br /> ASME-approved for intended use. <br /> <br />(2) <br /> <br />(3) <br /> <br />(4) <br /> <br />Tanks shall be securely fastened and located where <br />they will normally not be subject to damage. They <br />may be in a body compartment or underneath the <br />body. The tank or fittings must not protrude <br />beyond the body. <br /> <br />Tanks and regulators shall be separated from any <br />open flame by a vapor-tight partition. <br /> <br />When tanks are installed in a body compartment, the <br />partitions shall be scaled off from the rest of the <br />body with no openings to the interior except for <br />the tubing. The following additional requirements <br />shall be met: <br /> <br />a. Ail tank valves and fittings shall be readily <br /> <br />10 <br /> <br /> <br />