Laserfiche WebLink
<br />SPECIFICATIONS <br /> <br />Solid Waste collection and Recycling plastic carts ("carts") for curbside service, City of Santa Ana, <br />California <br /> <br />Description <br /> <br />Size A: 35 gallon <br />Depth: 23.75 inches maximum (including handles) <br />Width: 19 inches maximum <br />Height: 35 inches maximum (to body rim) <br /> <br />Size B: 64 gallon <br />Depth: 27 inches maximum (including handles) <br />Width: 24 inches maximum <br />Height: 39 inches maximum (to body rim) <br /> <br />Size C: 96 gallon <br />Depth: 34.5 inches maximum (including handles) <br />Width: 26 inches maximum <br />Height: 43 inches maximum (to body rim) <br /> <br />All three sizes must be available in green, grey and burgundy. <br /> <br />Technical Requirements <br /> <br />1. Body: Carts shall be injection molded of virgin high density polyethylene plastic. The body <br />of the cart shall be molded to present a smooth interior and exterior surface. The body ofthe <br />carts shall have a minimum wear strip under the floor of 12 inch (protecting the floor from <br />abrasive contact with the street surface). <br /> <br />2. Material: Recyclable polyethylene, UL. approved with a rating ofHB or better. <br /> <br />Average Wall Thickness: <br /> <br />Size A: <br />Size B: <br />Size C: <br /> <br />Not less than .140 inch <br />Not less than .160 inch <br />Not less than .165 inch <br /> <br />Carts shall be suitable for use in temperature of >1200 F to -20OP. All plastic and <br />component parts used in the construction of the carts shall be recyclable into other <br />polyethylene products. Crosslink resin is not acceptable. All carts shall be manufactured <br />with a minimum of20% post consumer recycle content. <br /> <br />Carts shall be manufactured with a UV stabilizer. The UV stabilizer shall be added in the <br />solution during the polymerization, prior to pelletizing, compounding and molding. <br />Independent laboratory tests of the carts bid must accompany bid samples certifying <br />compliance as specified in part 2 of the detailed specifications. <br /> <br />25A-44 <br />