Laserfiche WebLink
K. Use insulated spring wire nuts with plastic caps for copper conductor splices and <br />taps, 10 AWG and smaller. Ideal wingnuts or approved equal. Scotchlock type <br />wirenuts shall not be used. <br />3.3 INSTRUMENTATION CABLE INSTALLATION <br />A. Separate analog signals from power conductors and 110V control signals unless <br />otherwise noted. <br />B. Ground shield on shielded cables at one end only and as recommended by instrument <br />manufacturer. <br />C. Terminate stranded conductors with pre - insulated crimp type spade or ring type <br />terminals properly sized to fit fastening device and wire size. <br />D. Install and terminate vendor furnished cable in accordance with vendor equipment <br />requirements. <br />3.4 INTERFACE WITH OTHER PRODUCTS <br />A. Identify wire and cable under provisions of Section 16195. <br />B. Identify each conductor with its circuit number or other designation indicated on the <br />Drawings. <br />3.5 FIELD QUALITY CONTROL <br />A. Perform field inspections and testing under provisions of Section 01660. <br />B. Inspect wire and cable for physical damage and proper connections. <br />C. Measure tightness of bolted connections and compare torque measurements with <br />manufacturer's recommendations. <br />D. Test shielded instrumentation cable shields with an ohmmeter for continuity along the <br />full length of the cable and for shield continuity to ground. <br />E. Connect shielded instrumentation cables to a calibrated 3 -20 milliamp DC signal <br />transmitter and receiver. Test at 4, 12, and 20 milliamp transmitter settings. <br />3.6 OWNERS CONDUCTOR COLOR CODE REQUIREMENTS <br />A. CONTRACTOR shall follow the following color code requirements for conductors. On <br />3 -phase circuits, conductor insulation color shall be as shown. Wire and cable shall <br />be factory color -coded by integral pigmentation with a separate color for each phase <br />and neutral. On conductors larger than No.8 AWG, color tape or colored plastic <br />bands will be permitted. <br />Application Conductors Color <br />City of Santa Ana Wire and Cable <br />Security Management System Project Page 16123-4 <br />SantaAna_SMS_16123 <br />