SECURITY SOLUTIONS, INC. 2 - Laserfiche WebLink

Home Browse Search

D. Enclosures shall be sized to contain the equipment required to make the installation complete and suitable for the intended purpose. Electrical wiring shall be in plastic wireways and /or spot tied to present an orderly appearance. E. All equipment shall be located and installed so that it will be readily accessible for - operation and maintenance. The CITY reserves the right to require minor changes in location of equipment prior to roughing in without incurring any additional costs or charges. F. The CONTRACTOR shall instruct installation personnel on any and all installation requirements; thereafter, the technical field representative shall be readily available by telephone to answer questions and supply clarification when needed by the installation personnel. G. Final Checks: After all installation and connection work has been completed, the technical field representative shall check it all for correctness, verifying polarity of electric power and signal connections, and all other similar details. The technical field representative shall certify in writing to the CONTRACTOR that for each loop or system checked out, all discrepancies have been corrected by the installation personnel. 3.2 ENCLOSURE SIGNAL AND CONTROL CIRCUIT WIRING A. Wiring Installation: All wires shall be run in plastic wireways except field wiring. Wiring run from components on a swing -out panel to other components on a fixed panel shall be made up in tied bundles. These bundles shall be tied with nylon wire ties, and shall be secured to panels at both sides of the "hinge loop" so that the conductors are not strained at the terminals. Signal and low voltage wiring shall be run separately from power and 120 volt control wiring. B. Conformance to the above wiring installation requirements shall be reflected by details shown on the shop drawings for the ENGINEER'S review. C. Wire Marking: Each signal, control, alarm, and indicating circuit conductor connected to a given electrical point shall be designated by a single unique number which shall be shown on all shop drawings. These numbers shall be marked on all conductors at every terminal using white numbered wire markers which shall be plastic- coated cloth covered with clear heat shrink tubing, or permanently marked heat - shrink plastic. D. CONTRACTOR shall utilize a tag numbering system. Submit proposed numbering system drawings to ENGINEER for approval prior to start of work. 13 SITE DESCRIPTIONS -- A. West Reservoir: The overall dimensions of the West Reservoir site is approximately 200' x 340'. The site includes a reservoir (approximately 180' diameter x 32' tall), five booster pumps, a well, a Motor Control Center (MCC), a chemical building and three entrance gates. Houses and apartments border the South and East perimeters. Private business lots border the North and West perimeters. The 120 VAC power City of Santa Ana Security Management System Specific Requirements Security Management System Project Page 17100 -13 SantaAna_SMS -17100